Cisco VG202 Panduan Pemasangan Perangkat Keras - Halaman 30
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Gerbang Cisco VG202. Cisco VG202 48 halaman. Voice gateways
Juga untuk Cisco VG202: Panduan Konfigurasi Perangkat Lunak (50 halaman), Panduan Pemasangan Perangkat Keras (50 halaman), Manual (10 halaman), Panduan Memulai Cepat (19 halaman)
Halaman Cetak
Safety Recommendations
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
General Safety Practices
Follow these guidelines to ensure personal safety and protect the equipment:
•
•
•
•
•
Safety Tips
Use these tips as safety guidelines when installing or working around this equipment:
•
•
•
•
•
•
Preventing Electrostatic Discharge Damage
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD occurs when
electronic components are improperly handled; it can result in complete or intermittent failures.
Always follow ESD-prevention procedures when removing and replacing components.
•
•
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
3-2
Keep the chassis area clear and dust-free during and after installation.
Put the removed chassis cover in a safe place.
Keep tools away from walk areas where you and others could fall over them.
Do not wear loose clothing that could get caught in the chassis.
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Locate the emergency power-off switch for the room in which you are working. Then, if an electrical
accident occurs, you can act quickly to turn off the power.
Disconnect all power before installing or removing a chassis.
Do not work alone if potentially hazardous conditions exist.
Never assume that power is disconnected from a circuit. Always check.
Look carefully for possible hazards in your work area, such as moist floors, ungrounded power
extension cables, and missing safety grounds.
If an electrical accident occurs, proceed as follows:
Use caution; do not become a victim yourself.
–
Turn off power to the system.
–
If possible, send another person to get medical aid. Otherwise, assess the condition of the victim
–
and then call for help.
Determine if the person needs rescue breathing or external cardiac compressions; then take
–
appropriate action.
Ensure that the chassis is electrically connected to earth ground.
Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact.
Chapter 3
Installing the Voice Gateway
OL-15959-01