Epson Stylus Photo RX600 Mulai dari Sini Manual - Halaman 5

Jelajahi secara online atau unduh pdf Mulai dari Sini Manual untuk Pemindai Epson Stylus Photo RX600. Epson Stylus Photo RX600 10 halaman. Product support bulletin(s)
Juga untuk Epson Stylus Photo RX600: Tips (2 halaman), Lembar Informasi Produk (4 halaman), Informasi Produk (19 halaman), Brosur (2 halaman), Setup Manual (2 halaman), Panduan Memulai Cepat (28 halaman), Panduan Pengguna (12 halaman), Memperbarui (1 halaman), Buletin Dukungan Produk (6 halaman), Buletin Dukungan Produk (1 halaman), Spesifikasi (2 halaman), Cara Menyalin dan Mencetak (20 halaman), Panduan Instruksional (4 halaman)

Open the cartridge cover by pulling it toward you.

Remove the ink cartridges from their packages.

Caution: You must install all the cartridges

and leave them installed for all types of printing.

To avoid damaging the RX600, never move the

print head by hand.

Lower each cartridge into the holder marked

with the corresponding color.

Press down on each cartridge until it clicks

into place. Then close the ink cartridge cover

until it clicks into place.

Caution: Don't force the cartridge cover

closed. If it doesn't close easily, open it and

make sure all the cartridges are firmly seated.

Lower the scanner unit.

The RX600 begins charging the ink

delivery system.

Charging takes about 2 minutes. Initial

charge appears on the RX600 screen.

Caution: Don't turn the RX600 off while

you see the Initial charge message or

you'll waste ink.

Load Paper

Insert the paper support into the two slots on the back of the RX600.

Open the output tray.

Flip the feeder guard forward.

Place a stack of paper in the top

of the RX600, between the edge

guides and beneath their tabs.

Then slide the left edge guide

against the paper, but not

too tightly.

Flip the feeder guard back over the

stack of paper.

Note: If you don't flip the feeder

guard back, your paper may jam.

Turn over