DIGIWAY PTY P550 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pembuka Pintu Garasi DIGIWAY PTY P550. DIGIWAY PTY P550 12 halaman. Sliding gate motor
Juga untuk DIGIWAY PTY P550: Buku Petunjuk (13 halaman)

Halaman Cetak

until gate is fully opened. If the PE is clear, the gate will open another 2 seconds, then gate will close

again after PE close delay time. DIP5 OFF no this function. DIP5 is prior to DIP6.

Auto CLS (DIP6)

DIP6 ON selects Auto close mode. I this mode, the gate will auto close after standard auto closed time.

If DIP6 OFF, no this function.

5. Timer Settings

Push Buttons functions

Button

Dip1 on---STD Setting

OPN

Open Length Set

PED

Auto close time set

CLS

Manual close gate

OSC

Lock pulse time set

5.1 STD(standard) time setting mode

To get into standard setting mode, just set DIP1 to on. Following settings can be set in standard setting

model

Gate length set up -- Limit switch set up

a) Connect 240V AC (if not done) and make sure power is off.

b) Releases clutch and push gate to middle position, and then engage the clutch.

c) Make sure no signals connect to OPN, PED, OSC and PEB terminals. Set DIP6 on.

d) Turn power on, gate should start close at low speed. If not, turn power off, change motor direction

by swapping any two of three phases (from motor side)

e) Power on again. Gate should start to close. Look at RED LED should be flash and GREEN LED

is off. If not, turn power off, change encode plug to other connector.

f) Power on again, gate start close, RED LED is flash and GREEN LED is off. When gate hit the

closed stopper, gate will stop. For P550 the gate will open a little bit, do not move the gate, just

go to next step.

g) Set DIP1 on. Push and hold OPN button, gate will start open at low speed. When gate reach

opened position, (about 50mm away opened stopper). Just simply release the OPN button.

Controller will save the current position as fully opened position. While hold OPN button, push

and release PED button will save current gate position as PED opened position.

h) Set DIP1 off and push CLS button, gate will start to close. When gate fully closed, gate will be

ready to operate. Then try to open and close. If not satisfied with the position, just repeat step (g)

to (h).

Auto close time set

Push and hold on PED for the auto close time setting. Now the red and green LED flash fast

alternatively, When reached the required time simply release PED button. Set DIP1 OFF. The gate

controller will back to working mode.

Lock pulse time set

Push and hold on OSC for the lock pulse time setting. Now the red and green LED flash fast

alternatively, and when gate reached the required time, simply release OSC button. Set DIP1 OFF.

The gate controller will back to working mode.

5.2 SPE(special) time setting mode

To get into special setting mode, turn power off, set DIP1 on. Push and hold CLS button then turn

power on, LED will be on for short time, after LED off simply release CLS button. Gate controller is

getting into special time setting mode.

DIGIWAY PTY LTD

CONTROL BOARD SETTING

ON=AUTO CLS

SPE Setting

Sync delay time

Motor stop time set

PE close time set

Reserved

OFF=NO AUTO CLS

Dip1 off---Running

Full open

Pedestrian open

OSC