TomTom Runner & Multi-Sport Panduan Referensi - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Referensi untuk Menonton TomTom Runner & Multi-Sport. TomTom Runner & Multi-Sport 40 halaman. Gps sports watch
Juga untuk TomTom Runner & Multi-Sport: Panduan Referensi (30 halaman), Panduan Referensi (44 halaman)
Halaman Cetak
5. Select the metric to be displayed from the list.
The metrics that are available depend on your current activity.
Note: To choose to see speed, pace or both, move down to the Settings menu. Select Met-
rics, then move right. Select Speed, then move right. Select Speed, Pace or Both.
Settings for Cycle activities
Note: Cycle is available on the TomTom Multi-Sport.
If you are using a
cadence
of the metrics provided by the sensor. This setting is the circumference of your rear tyre in milli-
metres (mm).
To set your wheel size, do the following:
1. From the activity start screen, move down to open the Settings menu.
2. Select Wheel size, then move right.
3. Set the size so it's correct for your rear wheel.
To find the circumference of your rear wheel, you can either measure the wheel yourself using a
tape measure, or look up the value in an online calculator. For example, on this site you can find
the circumference using the diameter of the wheel and the thickness of the tyre:
www.bikecalc.com/wheel_size_math
For example, if your wheel size is 700c and the tyres are 25 mm thick, the circumference is 2111
mm. This is the value you should enter.
Settings for Swimming activities
Note: Swim is available on the TomTom Multi-Sport.
Before you start a swimming activity, you should check two settings:
The Pool size setting for the pool where you are swimming. This setting is the length of the
pool in metres or yards.
The Wrist setting for the wrist you wear your watch on.
As you swim, your watch registers your strokes and the number of turns you make in the pool. To
calculate the distance you have swum and your speed, your watch uses the pool size and the
number of turns you have made. If the pool size is not accurate, the metrics for your swimming
activity cannot be worked out correctly. Your watch needs to know which wrist you wear your
watch on so it can register your strokes.
To change the Pool size and Wrist settings, do the following:
1. From the activity start screen, move down to open the Settings menu.
2. Select Pool size, then move right.
3. Set the size so it shows the correct length for the pool.
4. Move left to go back to the Settings menu.
5. Select Wrist, then move right.
6. Change the setting to the wrist you wear your watch, if necessary.
7. Move right to go immediately back to the activity screen.
sensor, you should set the Wheel size setting to increase the accuracy
13