Acuity Controls ECLYPSE A1000 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 halaman. Asset tracking
Juga untuk Acuity Controls ECLYPSE A1000: Panduan Instalasi (14 halaman)

Halaman Cetak

Acuity Controls ECLYPSE A1000 Panduan Instalasi

1. Power Supply Information

4.0 - Communications Wiring

Controllers are uniquely identified on the network by

their MAC address. This identifier is printed on a label

located on the side of the controller and on its shipping

box. Get a printed copy of the building's floor plan.

During controller installation, peel the MAC address

stickers off of the shipping box and put it on the floor

plan where the controller has been installed. This MAC

address is used as part of the controller's factory-default

Wi-Fi access point name and its network hostname.

Bar Code

ID: MAC Address

Model: ECY-S1000

For example, for a MAC Address of : 76:a5:04:cd:4a:d1

The factory-default name for the Wi-Fi access point is ECLYPSE-CD4AD1

The factory-default hostname is eclypse-cd4ad1.local

Figure 11: Finding the Controller's MAC Address

There are two methods to connect to the controller: wi-

red (Ethernet connection) or wireless (when the ECLYPSE

Wi-Fi Adapter is connected to the controller).

4.1 Wired Connection

Network connections can be daisy-chained.

5.0 - Configuring the Controller

Any of the following methods can be used to connect to

the controller's interface in order to configure it:

•

Using the controller's factory-default Hostname in

the Web browser

•

Using the controller's IP address in the Web browser

5.1 Using the Factory-default Hostname in a

Web Browser

Controllers have a factory-default hostname that you can

use instead of an IP address to connect to it. The

hostname can be used in a Web browser's address bar.

When installing the latest version of the configuration

Label

Connector

To Router /

Next IP Device

Figure 12: Communications Wiring

4.2 Wi-Fi Connection

Connect the WiFi Adapter to one of the HOST connec-

tor of the server module.

Once the ECLYPSE Wi-Fi Adapter has been connected

to the controller, a Wi-Fi hotspot becomes available that

allows you to connect to the controller's configuration

Web interface with your PC.

On your PC's wireless networks, look for an access point

named ECLYPSE-XXYYZZ where XXYYZZ are the last 6

hexadecimal characters of the controller's MAC address

(see above). The default password for the wireless

network is: eclypse1234

4.3 Wi-Fi Connection

Connect the BLE Adaptor to one of the HOST connector

of the server module.

web interface program and your PC does not have the

Bonjour service installed, a link to install the Bonjour

service is provided. The Bonjour service must be

installed on your PC to allow your PC to discover

controllers by their hostname.

If your PC is unable to resolve the controller's hostname,

you must connect your PC to the controller through

Ethernet or Wi-Fi so that your PC only sees the controller

network. For example, in this case, your PC must be

disconnected from all other networks such as a

corporate network or the Internet. If necessary, tempora-

rily disconnect your PC's network cable from its Ethernet

port.

Cat 5e

Network

RJ-45

Cable

To Next IP

Device

A1000AT_IG_10_EN

7 of 10