Acuity Controls ECLYPSE A1000 Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Контролер Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 сторінок. Asset tracking
Також для Acuity Controls ECLYPSE A1000: Посібник з монтажу (14 сторінок)
Друкувати сторінку
4.0 - Communications Wiring
Controllers are uniquely identified on the network by
their MAC address. This identifier is printed on a label
located on the side of the controller and on its shipping
box. Get a printed copy of the building's floor plan.
During controller installation, peel the MAC address
stickers off of the shipping box and put it on the floor
plan where the controller has been installed. This MAC
address is used as part of the controller's factory-default
Wi-Fi access point name and its network hostname.
Bar Code
ID: MAC Address
Model: ECY-S1000
For example, for a MAC Address of : 76:a5:04:cd:4a:d1
The factory-default name for the Wi-Fi access point is ECLYPSE-CD4AD1
The factory-default hostname is eclypse-cd4ad1.local
Figure 11: Finding the Controller's MAC Address
There are two methods to connect to the controller: wi-
red (Ethernet connection) or wireless (when the ECLYPSE
Wi-Fi Adapter is connected to the controller).
4.1 Wired Connection
Network connections can be daisy-chained.
5.0 - Configuring the Controller
Any of the following methods can be used to connect to
the controller's interface in order to configure it:
•
Using the controller's factory-default Hostname in
the Web browser
•
Using the controller's IP address in the Web browser
5.1 Using the Factory-default Hostname in a
Web Browser
Controllers have a factory-default hostname that you can
use instead of an IP address to connect to it. The
hostname can be used in a Web browser's address bar.
When installing the latest version of the configuration
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2017-2019 Acuity Brands Lighting, Inc. All rights reserved. 03/29/19
Label
Connector
To Router /
Next IP Device
Figure 12: Communications Wiring
4.2 Wi-Fi Connection
Connect the WiFi Adapter to one of the HOST connec-
tor of the server module.
Once the ECLYPSE Wi-Fi Adapter has been connected
to the controller, a Wi-Fi hotspot becomes available that
allows you to connect to the controller's configuration
Web interface with your PC.
On your PC's wireless networks, look for an access point
named ECLYPSE-XXYYZZ where XXYYZZ are the last 6
hexadecimal characters of the controller's MAC address
(see above). The default password for the wireless
network is: eclypse1234
4.3 Wi-Fi Connection
Connect the BLE Adaptor to one of the HOST connector
of the server module.
web interface program and your PC does not have the
Bonjour service installed, a link to install the Bonjour
service is provided. The Bonjour service must be
installed on your PC to allow your PC to discover
controllers by their hostname.
If your PC is unable to resolve the controller's hostname,
you must connect your PC to the controller through
Ethernet or Wi-Fi so that your PC only sees the controller
network. For example, in this case, your PC must be
disconnected from all other networks such as a
corporate network or the Internet. If necessary, tempora-
rily disconnect your PC's network cable from its Ethernet
port.
Cat 5e
Network
RJ-45
Cable
To Next IP
Device
A1000AT_IG_10_EN
7 of 10