Acuity Controls ECLYPSE A1000 Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Relai Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 halaman. Asset tracking
Juga untuk Acuity Controls ECLYPSE A1000: Panduan Instalasi (14 halaman)

Halaman Cetak

Acuity Controls ECLYPSE A1000 Panduan Instalasi

1. Power Supply Information

7.0 - Sub-gigahertz Assets Adapter

Mounting Instructions

Figure 14: Ceiling Mounting

7.3 Instructions for NPT Mounting

1. Remove the 3/4 inch electrical panel knockout or use

a 01.115" (26.9 to 32.5mm) hole punch to create a

mounting hole position.

2. Unbox the Assets Adapter, remove nut from the

adapter, make sure the gasket is on the adapter,

place nut on the USB cable and hand tighten nut to

the enclosure.

3. Plug-in the USB connector into the USB host slot on

the ECLYPSE.

Do not mount a wireless adapter inside of metal enclosures.

Figure 15: Wireless Adapter Installation

7.4 Location Tips for ECLYPSE A1000AT using

Wireless Adapters

When installing a wireless adapter, it is important to

ensure that distances and obstructions do not impede

NUT

INTERNAL TOOTH

LOCK WASHER

GASKET

SUSPENDED CEILING

PANEL/MOUNTING

SUPPORT

ADAPTER

transmission. Metallic parts, such as reinforcement in

walls, machinery, office furniture, etc. are major sources

of field strength dampening. Furthermore, supply areas

and elevators shafts should be considered as complete

transmission screens. See Figure 16.

Figure 16: Wireless Transmission Screens

For transmission obstructions, one way to get around

an obstruction, such as a duct, is to place the wireless

adapter on the side of the obstruction that is nearer to

the coordinating wireless device, even if the controller is

on the opposite side of the obstruction. But always keep

in mind that the wireless adapter performs best when it

is away from metal objects or surfaces.

Two common sources of the wireless obstructions in the

field are when the wireless adapter is placed in a high

angle of incidence and when two wireless adapters are

placed along the same wall. A steep angle of incidence

may cause a signal to run through more obstructions

than realized, dampening the signal. Therefore it is

preferable that the transmission be arranged so that it

travels straight or perpendicuarly through the obstruc-

tion. See Figure 17.

Linked wireless adapters should not be mounted on the

same wall or plane. Radio waves are subject to interfer-

ing reflections. It is always best to place the linked wire-

less antennas on the side or opposite walls. See Figure

18 .

Figure 17: High Angle of Incidence

Figure 18: Wall Reflectance

A1000AT_IG_10_EN

10 of 10