Epson TM-L90 series Panduan Manufaktur - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Manufaktur untuk Aksesori Printer Epson TM-L90 series. Epson TM-L90 series 22 halaman. Attaching cover on the power switch
Juga untuk Epson TM-L90 series: Brosur (1 halaman), Brosur (2 halaman), Panduan Produk (27 halaman), Spesifikasi (2 halaman), Spesifikasi (8 halaman), Manual Informasi (5 halaman), Spesifikasi (4 halaman), Panduan Pengguna (40 halaman), Panduan Pengguna (17 halaman), Panduan Pengguna (21 halaman), Panduan Pengguna (21 halaman), Mulai di sini (2 halaman), Mulai di sini (2 halaman), Manual (13 halaman), Petunjuk Manual (12 halaman), Panduan Pengguna (36 halaman), Panduan Pengembangan (34 halaman), Manual (2 halaman)

Confidential

4.4 Requirements for Size of Continuous Label Paper

To make a cut-off edge, be sure to manufacture label paper that meets the requirements in the

figure below:

Note: "cut-off edge" is a method of cutting and removing the edge of the label in advance so that

the label can be peeled off easily from the backing paper.

Requirements for Size of Label Paper of the Cut-Off Edge Type

NOTES: *1. When performing a full-cut, for the cut-off edge (a): 3.5 mm {0.14"} or more is not

necessary; however, even though it is not necessary, it is recommended that

cut-off edges with approximately 2 mm {0.79"} width be provided for (a) and (b) so

that the label can be peeled off easily from the backing paper.

*2. When using a label with 80 mm {3.15"} paper width, the cut-off edge (b) is not

necessary. However, when labels with a width between 38 ~ 70 mm {1.5 ~ 2.76"}

are used, be sure to make the cut-off edge (b): 0.3 mm {0.12"} or more to prevent

the adhesive agent of the label roll paper from being attached to the platen.)

*1 cut-off edge (a):

3.5 mm {0.14"} or more

Face stock (printing side)

TITLE

TM-L90

Roll Paper

Manufacturing Guide

*2 cut-off edge (b):

0.3 mm {0.12"} or more

Paper feeding

direction

SHEET

REVISION

NO.

SHEET