Epson 1715C - PowerLite XGA LCD Projector Panduan Pengoperasian - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Perangkat lunak Epson 1715C - PowerLite XGA LCD Projector. Epson 1715C - PowerLite XGA LCD Projector 47 halaman. Remote control information
Juga untuk Epson 1715C - PowerLite XGA LCD Projector: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Pengaturan Cepat (4 halaman), Panduan Instalasi (19 halaman), Panduan Pengguna (1 halaman), Daftar Bagian (1 halaman), Pembaruan Dokumentasi (12 halaman), Manual Fungsi (5 halaman), Manual Perangkat Lunak (2 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (34 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman), Spesifikasi (2 halaman), Buku Panduan Instalasi (8 halaman)

Registering and deleting projectors for monitoring

After entering the details, click "Register" to start the

registration. When the message is displayed, click "OK".

To continue registering other projector(s), repeat Steps 1 and 2.

Projectors that have been registered using automatic search are searched

for again by projector name each time EasyMP Monitor is started.

To end the registration operation, click

corner of the window or click "Cancel".

The icon(s) of the projector(s) you registered will be displayed in

Grouping view or Detail list view.

Refer to s "Monitoring window layout"

the Grouping view and Detail list view.

Setting the range of addresses to do an automatic

search and registration

Projectors that are using a serial W TCP/IP conversion adapter cannot be

detected.

Procedure

Right-click in Grouping view and select "New" - "Projector

(automatic search)".

The Create new projector (automatic registration) window will be

displayed.

If Detail list view is displayed, select New - Projector (automatic

search) from the Edit menu.

in the top-right

p.21

for details on using

Select the "Specify an address range and search." check box

and then enter "Start address" and "End address" in the

range.