Toshiba 16J2AVSG-E1 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pendingin Udara Toshiba 16J2AVSG-E1. Toshiba 16J2AVSG-E1 20 halaman. Air conditioner (split type)
Juga untuk Toshiba 16J2AVSG-E1: Panduan Instalasi (20 halaman)

Halaman Cetak

9.5 FIREPLACE OPERATION

Keep indoor unit's fan blowing continuously during thermo off, to circulate

heat from other sources over the room. There are three setting parameters:

Default setting > Fireplace 1 > Fireplace 2

Fireplace 1:

● During thermo off period, the indoor unit's fan will continue to run by the

same speed, previously selected by end-user.

Fireplace 2:

● During thermo off period, the indoor unit's fan will continue to run at

super-low speed, programmed from factory.

Fireplace Operation Setting

1. Press MENU button for enter menu setting and press TEMP. button to

select FIREPLACE

2. Enter FIREPLACE set by press MENU button.

triangle mark will stop blink and setting feature will be blink instead.

3. Select FIREPLACE operation by press TEMP. button.

FIREPLACE 1

FIREPLACE 2

4. Confirm selected feature by press MENU button again.

When feature had selected will return to menu selection display triangle mark

will blink

5. Leave from menu setting display by select EXIT.

Note:

● While Fireplace operation on heating mode, indoor unit fan always runs and

cold air breezing might be occurred.

● Fireplace will operate in Heating mode only.

Blink both triangle and

feature mark Feature not

°C

yet set

°C

None

Blink only triangle Feature

already set

°C

9.6 TIMER OFF OPERATION

To set the timer OFF when the air conditioner is operating.

1. Press MENU button for enter menu setting and press TEMP. button to

select TIMER OFF.

2. Enter TIMER set by press MENU button.

triangle mark will stop blink and setting feature will be blink instead.

3. Select TIMER OFF by press TEMP. button.

Can select TIMER OFF from 0.5 - 12hrs.

4. Confirm TIMER OFF by press MENU button.

5. Leave from menu setting display by select EXIT.

Note:

● Keep the remote control in accessible transmission to the indoor unit;

otherwise, the time lag of up to 15 minutes will occur.

● The setting will be saved for the next same operation.

Cancel TIMER OFF

6. During TIMER OFF already set (no.5) press MENU button and press

TEMP. button to select TIMER OFF.

7. Press MENU button again will cancel TIMER OFF.

8. Leave from menu setting display by select EXIT.

Blink both triangle and

feature mark Feature not

°C

yet set

Blink only triangle

Feature already set

°C

Blink only triangle

Feature already set

°C

Blink both triangle and feature

mark Feature not yet set

°C