Toshiba 16J2AVSG-E1 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pendingin Udara Toshiba 16J2AVSG-E1. Toshiba 16J2AVSG-E1 20 halaman. Air conditioner (split type)
Juga untuk Toshiba 16J2AVSG-E1: Panduan Instalasi (20 halaman)

Halaman Cetak

9.7 PLASMA ION OPERATION

Capture efficiency of floating impurities in the air is accelerated by plasma ion

contaminates such as bacteria, odor, smoke, dust and virus are caught and

deactivated by Plasma Ion.

1. Press MENU button for enter menu setting and press TEMP. button to

select PURE

2. Confirm selected feature by press MENU button again.

3. Leave from menu setting display by select EXIT.

Note:

● Plasma Ion operation dose not remove harmful substances from cigarette

smoke (carbon monoxide etc.). Open a window occasionally for ventilation.

9.8 POWER-SELECTION OPERATION

To automatically control room temperature to save energy (except in DRY and

FAN ONLY mode)

1. Press MENU button for enter menu setting and press TEMP. button to select

POWER-SEL

2. Enter POWER-SEL setting by press MENU button again.

3. Select POWER-SEL level by press TEMP. button.

100%

75%

4. Confirm POWER-SEL level by press MENU button.

5. Leave from menu setting display by select EXIT.

PURE

Blink both triangle and

°C

feature mark Feature not

°C

yet set

°C

Blink only triangle Feature

already set

°C

Blink only triangle

°C

50%

°C

MANUAL DEFORST OPERATION

To defrosting the heat exchanger of the outdoor unit during Heating operation

Press and hold

: for 5 seconds , then remote control display will

show

as picture 1 for 2 seconds.

DISPLAY LAMP BRIGHTNESS ADJUSTMENT

To decrease the display lamp brightness or turn it off.

FAN

1. Press and hold

) is shown on remote control LCD then release the button.

2. Press

Rise

Decrease

Remote control

Operation display

LCD

Lamp illuminates full brightness.

Lamp illuminates 50% brightness.

Lamp illuminates 50% brightness and the

operation lamp is turned off.

All lamps are turned off.

● In the examples of

and

, the lamp illuminates for 5 seconds before going off.

AUTO RESTART FUNCTION SETTING

This product is designed so that, after a power failure, it can restart automatically

in the same operating mode as before the power failure.

Information

The product was shipped with Auto Restart function in the OFF position.

Turn it ON as required.

How to turn ON the Auto Restart Function

● Press and hold the [OPERATION] button on the indoor unit for 3 seconds

(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).

How to turn OFF the Auto Restart Function

● Press and hold the [OPERATION] button on the indoor unit for 3 seconds

(3 beep sounds but OPERATION lamp does not blink).

Notes :

● In case of ON timer or OFF timer are set, AUTO RESTART OPERATION

does not activate.

SELF CLEANING OPERATION

(COOL AND DRY OPERATION ONLY)

To protect bad smell caused by the humidity in the indoor unit.

1. If the

button is pressed once during "Cool" or "Dry" mode,

the fan will continue to run for other 30 minutes, then it will turn off

automatically. This will reduce the moisture in the indoor unit.

2. To stop the unit immediately, press the

seconds.

for 3 seconds until brightness level (

to adjust brightness in 4 levels.

Brightness

All turned off

more 2 times within 30

100%

50%