Eckman EKETC6 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Anakan Eckman EKETC6. Eckman EKETC6 15 halaman. With optional roller

VI. Mower Blade Calibration Adjustments

The blades on the push mower are all calibrated prior to leaving the factory and generally do

not require adjustment .However adjustments may be required only if you notice a rough,

uneven cut; the mower is

note before proceeding, adjusting the blades is a very sensitive procedure. A turn(adjustment)

of 1/16 is considered a major adjustment! Carefully follow the procedures below.

Proper calibration is achieved when the cutting blades are adjusted so that the rotating cutting

reel ever so slightly comes in even contact along the entire length of the cutting bar

,creating a shearing or scissor-like effect.

WARNING The cutting bar and the rotating reel blades can be damaged if they are

adjusted too close to each other.

1. Loosening the blades

The cutting bar must be moved away from the rotating cutting reel by turning the spring loaded

screws equally counter clockwise. Be sure to loosen both spring loaded screws on both sides of the

mower the same amount of turns (see Figure

2.Tightening the blades

The cutter bar must be moved closer the cutting reel by turning the spring loaded screws equally

clockwise. Be sure to tighten the spring loaded screws on both sides of the mower the same

amount same of turns(see Figure

3.Checking the adjustments

a).Turn the mower upside down.

difficult

to push, or the mower simply does not cut the grass. Please

2). Use very fine adjustments!