Epson PowerLite 737c Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson PowerLite 737c. Epson PowerLite 737c 42 halaman. Release of check tool for network projectors v1.00 for windows
Juga untuk Epson PowerLite 737c: Panduan Pengoperasian (36 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengoperasian (47 halaman), Daftar Bagian (1 halaman), Buletin Dukungan Produk (30 halaman), Informasi Produk (24 halaman), Panduan Instalasi (19 halaman), Panduan Pengguna (1 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (38 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (42 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (34 halaman), Buletin Dukungan Produk (38 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman), Pengaturan Cepat (2 halaman)

Registering and deleting projectors for monitoring

After entering the details, click "Register" to start the

registration. When the message is displayed, click "OK".

To continue registering other projector(s), repeat Steps 1 and 2.

Projectors that have been registered using automatic search are

searched for again by projector name each time EMP Monitor is

started.

To end the registration operation, click

corner of the window or click "Cancel".

The icon(s) of the projector(s) you registered will be displayed in

Grouping view or Detail list view.

Refer to s "Monitoring window layout"

the Grouping view and Detail list view.

Setting the range of addresses to do an automatic

search and registration

Projectors that are using a serial TCP/IP conversion adapter cannot be

detected.

Procedures for automatic search

Procedure

Right-click in Grouping view and select "New" - "Projector

(automatic search)".

The Create new projector (automatic registration) window will be

displayed.

If Detail list view is displayed, select New - Projector (automatic

search) from the Edit menu.

in the top-right

p.21

for details on using

Select the "Specify an address range and search" check box

and then enter "Start address" and "End address" in the

range.