Epson Stylus Pro 10000 Series Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson Stylus Pro 10000 Series. Epson Stylus Pro 10000 Series 13 halaman. Auto take-up reel unit
Juga untuk Epson Stylus Pro 10000 Series: Spesifikasi (6 halaman), Informasi Produk (16 halaman), Panduan Instalasi (26 halaman), Panduan Instalasi Cepat (34 halaman), Panduan Referensi Cepat (12 halaman), Garansi (28 halaman), Panduan Referensi Cepat (12 halaman), Spesifikasi (4 halaman), Spesifikasi (1 halaman), Panduan Perakitan (12 halaman)

Installing the drive unit

1. Attach the drive unit on the horizontal strut as

shown below.

2. Tighten the two screws to attach the drive unit

to the printer securely.

3. Plug the cable connector into the connector on

top of the control box of the drive unit, then

tighten the screws on both sides of the connector.

4. Plug the other end of the cable connector into

the connector on the back of the printer as

shown below, then tighten the screws on both

sides of the connector.

Downloaded from:

http://www.usersmanualguide.com/

Installing the movable unit

1. Turn the lock lever to the left to release it.

2. While holding the movable unit, attach the

movable unit stopper on the bottom of the

movable unit. Snap the two protrusions of the

stopper into the movable unit, so the stopper

does not fall off.

3. Tighten the two screws to attach the movable

unit to the horizontal strut.