Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Referensi Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Referensi Cepat untuk Perangkat lunak Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 10 halaman. Product support bulletin
Juga untuk Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine: Brosur & Spesifikasi (8 halaman), Lembar Spesifikasi (8 halaman), Panduan Instalasi Cepat (34 halaman), Informasi Produk (17 halaman), Spesifikasi (4 halaman), Buletin Dukungan Produk (44 halaman), Panduan Perakitan dan Pengaturan (14 halaman)

Halaman Cetak
Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Referensi Cepat
Control Panel Messages (Continued)
Control Panel Messages (Continued)
Error messages (Continued)
Message
PAPER JAM
PAPER NOT STRAIGHT
SERVICE REQ.
<error number>
TURN PWR OFF AND
ON

Where To Get Help

Where To Get Help
Service
Telephone support
World Wide Web
Support for non-EPSON RIP
EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON UltraChrome, EPSON Archival, and
EPSON Photographic Dye are trademarks and EPSON Preferred is a service mark of Epson America, Inc.
Copyright © 2002 by Epson America, Inc.
Light
Explanation
Paper Out light
Paper has jammed in the
flashing
printer.
Paper Out light on
Paper was fed at an angle.
All lights flashing
An error has occurred.
This message appears after
you clear a paper jam.
Access
Call (888) 377-6611. Make sure
you have your Unit ID number.
If you experience any difficulty with the toll-free number or your Unit ID
number, call (562) 276-1305.
Go to http: //support.epson.com to download drivers, access product
documentation and troubleshooting, and get technical advice
through e-mail.
Contact the RIP manufacturer.
Response
Pull the paper set lever all the
way out and open the lower
cover if necessary. Then remove
the jammed paper, close the
lower cover, and push the lever
in. Turn the printer off and then
back on.
Reload paper, making sure the
edges are straight and lined up
with the rows of holes.
Note the error number, and turn
the printer off and then on. If the
message remains, contact
EPSON.
Turn the printer off and then on
again.
Place your EPSON Preferred
9
SM
Unit ID label here
8/02