Toshiba MJ-1101 Adendum Manual Layanan - Halaman 10
Jelajahi secara online atau unduh pdf Adendum Manual Layanan untuk Semua dalam Satu Printer Toshiba MJ-1101. Toshiba MJ-1101 17 halaman. Supplement to the troubleshooting section
Halaman Cetak
Error code
Phenomenon
Possible cause
EA70
- When more than one
6. STAY-BUFFER deformed
EA60
sheet of paper is
CC30
loaded on the buffer
CC41
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
transported from the
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
7. Improper installation of
finishing tray to the
alignment plates
movable tray, the
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
8. Stack transport motor belt out
of gear
Items to confirm / Countermeasures
Remove the bracket of the buffer roller lift solenoid. Then check that STAY-BUFFER is not deformed using a
scale or other straight tool. Replace it if it is deformed.
STAY-BUFFER
Normal
A gap appears if it is deformed.
If the front or rear alignment plate is removed or its installation is improper, reinstall it. (The alignment plates must
not be risen even if they are tilted to the right or left.)
Alignment plate
If the stack transport motor belt is loose, retighten it, or replace the motor bracket (BRKT-MOTR-SF) to retighten
the belt.
Scale
Abnormal
Rising of the plate
Precautions / Remarks