Toshiba MJ-1101 Adendum Manual Layanan - Halaman 9
Jelajahi secara online atau unduh pdf Adendum Manual Layanan untuk Semua dalam Satu Printer Toshiba MJ-1101. Toshiba MJ-1101 17 halaman. Supplement to the troubleshooting section
Halaman Cetak
Error code
Phenomenon
Possible cause
EA70
- When more than one
4. Improper spacing on the edge
EA60
sheet of paper is
section of the buffer roller guide
CC30
loaded on the buffer
and the buffer tray upper section
CC41
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
transported from the
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
5. Motor bracket deformed
finishing tray to the
movable tray, the
(The bracket of the buffer tray
paper exit guide
guide motor or the buffer roller
catches the paper and
drive motor is deformed and thus
thus a motor error
drive is not transmitted.)
occurs because the
paper cannot exit.
Items to confirm / Countermeasures
Turn the power OFF and pull the plunger of the buffer roller lift solenoid by hand. Then check the spacing on the
edge section of the buffer roller guide and the buffer tray upper section while the buffer roller is lifted up. If the
edge section of the buffer roller guide is not lower than the buffer tray upper section, replace STAY-BUFFER.
Buffer roller lift solenoid
STAY-BUFFER
Buffer roller
RLR-EXIT-BUFFER
Buffer roller edge section
LVR-E-RLR-BUF
If the buffer tray guide motor bracket (HLDR-TRAY-BUF) or the buffer roller drive motor bracket (HLDR-MOTR-
BUFFER) is deformed, replace it.
Buffer tray guide motor
Buffer roller drive motor
Normal
A gap appears due to the
deformed bracket.
Normal
Buffer tray upper section
RLR-EXIT-TRY
Buffer tray
Abnormal
Precautions / Remarks
- If the joint surfaces of the stationary tray and the rear lower cover (or the
control panel unit) are shifted 4 mm or more, the motor bracket may be
deformed.
- Do not hold the stationary tray when unpacking.