ARIETE 440 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Dapur ARIETE 440. ARIETE 440 12 halaman. Electric grater
Juga untuk ARIETE 440: Manual (12 halaman)

Halaman Cetak

Lever

Start-up switch

Machine body

Charging contact

Recharge base

Charging unit

Charging pilot light

SUPPORT

Fig. 1 - 1bis The charging unit is a convenient support for the gratì, both horizontally and vertically.

Fig. 2 Place the base on the desired point, and mark the points to be drilled into the holes with a pencil.

Drill holes on the wall and introduce the dowels and screws.

USE

Fig. 3 Cut the food in small squares (remove the cheese rind), put them in the hopper, lower the lever.

Fig. 4 Press the start button. Fig. 5 gRATÌ is provided with a practical and simple plug to keep the

unused food in the hopper and roll. The plug protects the roll from dirt or dust.

REMOvING/ FITTING THE ROllER

Fig. 6 Turn off the motor, then rotate the indented ring nut anticlockwise by about 1/4 and draw the roll

outwards. Fig. 7 To refit, introduce the roller into its housing, keep it pressed and rotate clockwise by

about 1/4. A click will signal the automatic link.

REMOvING/ FITTING THE HOPPER AN THE ExTERNAl PROTECTION

Fig. 8 To disassemble the hopper, turn off the motor, rotate the indented ring nut anticlockwise by

about 1/4 and remove the roller. Fig. 9 Lift the lever. Fig. 10 Draw the hopper outwards, as shown in

the figure. Fig. 11 Separate the hopper from the external protection by pulling slightly. Fig. 12 To refit

the hopper, align the three grooves with the three hooks on the external protection, press slightly until

you hear a click. Fig. 13 Place back the unit into the machine body housing and press slightly until

you hear a click.

REMOvING/ FITTING THE RUBBER PRESS

Fig. 14 To remove the pusher, pull it firmly out of its seat. Fig. 15 To refit the rubber press, introduce

it into its housing and press with strength, taking care that the tongue matches with the provided slot

on the lever.

ClEANING

Opening the appliance and trying to intervene inside it is strictly forbidden. Keep the appliance

clean, it will thus guarantee excellent quality products and last longer. Do not put the motor body

into water or into other liquids. All the objects shown in the picture (Fig. 16) can be washed by

hand in warm water with mild detergents or in the upper drawer of the dishwasher.

Do not use potentially abrasive products.