Aeon Labs Aeotec Siren Gen5 ZW080 Instalasi dan Spesifikasi - Halaman 4
Jelajahi secara online atau unduh pdf Instalasi dan Spesifikasi untuk Sistem Keamanan Aeon Labs Aeotec Siren Gen5 ZW080. Aeon Labs Aeotec Siren Gen5 ZW080 7 halaman.
Halaman CetakChanging Sounds and Volume.
You may want to change your sound and volume of your Siren Gen5 to cater to your
application. There are 5 separate sounds, and 3 volume settings.
You must use Parameter 37 to change the tone and volume of the Siren. In order to
make this setting change, your gateway must support the Configuration Command
Class otherwise this is not possible.
By setting Parameter 37 [2 byte hex] using the list above, you would set it as
0x[value1][value2]
Value 1 sets the sound
Value 2 sets the volume.
For some examples:
•
If you want sound 3 with volume of 1, then you would set Parameter 37 [2 byte] =
0x301
•
If you want sound 1 with volume of 3, then you would set Parameter 37 [2 byte] =
0x103
•
If you want sound 5 with volume of 2, then you would set Parameter 37 [2 byte] =
0x502
If your software or gateway does not use hex values, you can take any Hex to
Decimal calculator to change this.
decimal-converter
http://www.binaryhexconverter.com/hex-to-