Aeon Labs Aeotec Siren Gen5 ZW080 설치 및 사양 - 페이지 4

{카테고리_이름} Aeon Labs Aeotec Siren Gen5 ZW080에 대한 설치 및 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec Siren Gen5 ZW080 7 페이지.

Changing Sounds and Volume.

You may want to change your sound and volume of your Siren Gen5 to cater to your

application. There are 5 separate sounds, and 3 volume settings.

You must use Parameter 37 to change the tone and volume of the Siren. In order to

make this setting change, your gateway must support the Configuration Command

Class otherwise this is not possible.

By setting Parameter 37 [2 byte hex] using the list above, you would set it as

0x[value1][value2]

Value 1 sets the sound

Value 2 sets the volume.

For some examples:

•

If you want sound 3 with volume of 1, then you would set Parameter 37 [2 byte] =

0x301

•

If you want sound 1 with volume of 3, then you would set Parameter 37 [2 byte] =

0x103

•

If you want sound 5 with volume of 2, then you would set Parameter 37 [2 byte] =

0x502

If your software or gateway does not use hex values, you can take any Hex to

Decimal calculator to change this.

decimal-converter

http://www.binaryhexconverter.com/hex-to-