Pioneer VSX-821-K Panduan Petunjuk Pengoperasian - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penerima Stereo Pioneer VSX-821-K. Pioneer VSX-821-K 20 halaman. Audio/video multi-channel receiver
Juga untuk Pioneer VSX-821-K: Spesifikasi (2 halaman), Panduan Servis (9 halaman)
Halaman Cetak
Connecting your equipment
• Turning on/off the device connected to this unit's HDMI OUT
terminal during playback, or disconnecting/connecting the
HDMI cable during playback, may cause noise or interrupted
audio.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing, LLC in the
United States and other countries.
"x.v.Color" and
are trademarks of Sony
Corporation.
Analog audio cables
Use stereo RCA phono cables to connect analog audio
components. These cables are typically red and white, and you
should connect the red plugs to R (right) terminals and white
plugs to L (left) terminals.
L
White (Left)
R
Red (Right)
Digital audio cables
Commercially available coaxial digital audio cables or optical
cables should be used to connect digital components to this
receiver.
C O A
X I A
L
Coaxial digital
I N
audio cable
Optical cable
Note
• When connecting optical cables, be careful when inserting the
plug not to damage the shutter protecting the optical socket.
• When storing optical cable, coil loosely. The cable may be
damaged if bent around sharp corners.
• You can also use a standard RCA video cable for coaxial digital
connections.
Video cables
Standard RCA video cables
These cables are the most common type of video connection and
are used to connect to the composite video terminals. The yellow
plugs distinguish them from cables for audio.
Component video cables
Use component video cables to get the best possible color
reproduction of your video source. The color signal of the TV is
divided into the luminance (Y) signal and the color (P
signals and then output. In this way, interference between the
signals is avoided.
A U D
I O
Green (Y)
O P T
I C A
L
I N
V I D
E O
Yellow
and P
B
C O
M P
O N
E N
Y
T V
I D E
P
O
B
P
R
Blue (P
)
B
Red (P
)
R
About video outputs connection
This receiver is not loaded with a video converter. When you use
component video cables or HDMI cables for connecting to the
input device, the same cables should be used for connecting to
the TV.
The signals input from the analog (composite and component)
video inputs of this unit will not be output from the HDMI OUT.
Terminal for connection with source device
)
R
IN
IN
Y
P
B
HDMI
COMPONENT VIDEO
OUT
MONITOR
OUT
Y
P
B
HDMI
COMPONENT VIDEO
Terminal for connection with TV monitor
The OSD will
not appear.
Video signals can be output.
02
02
Playback component
IN
P
R
VIDEO
MONITOR
OUT
P
R
VIDEO
TV
13
En