Pioneer VSX-D3S Petunjuk Pengoperasian - Halaman 16

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Penerima Stereo Pioneer VSX-D3S. Pioneer VSX-D3S 40 halaman. Audio/video stereo receiver
Juga untuk Pioneer VSX-D3S: Panduan Petunjuk Pengoperasian (40 halaman)

Halaman Cetak

OPERATING THE TUNER

Press the POWER switch to the ON position.

Select TUNER with the input selector button.

Be sure to turn the TAPE 2 MONITOR button off when listening to

AM or FM broadcasts.

Switch on the SPEAKERS button corresponding to the speakers

you wish to use.

FM auto stereo reception and monaural reception

Each time you press the MPX MODE button, the MONO indicator

in the display section lights or goes out.

÷ If an FM stereo broadcast is received when the MONO indicator

is out, the STEREO indicator lights and sound is in stereo.

÷ If an FM stereo broadcast is received when the MONO indicator

is lit, the sound will be monaural. If there is interference during

stereo mode reception, switch to mono. The sound will become

monaural but interference will be reduced.

TUNING INTO STATIONS

Turn the MULTI-JOG and the tuning frequency changes.

(Switch off when the GUI MODE button is on.)

Turning in a clockwise direction raises the frequency, while

turning in a counterclockwise direction lowers the frequency.

SELECT

1. Use the FM/AM button to select either FM or AM.

When the "ST CALL" indicator is lit in the display, press the

SELECT button to switch it off.

2. Turn the MULTI-JOG until you reach the frequency of a

desired station.

When a station is received, the TUNED indicator will light up.

NOTE:

The TUNED indicator may not light with broadcasts received

over long distances, or when the broadcast signals are extremely

weak.

3. Adjust the volume and tone as desired.

Auto tuning

Auto tuning is convenient when you do not remember the

frequency of a desired station, or when you wish to find stations

that you do not normally listen to.

Operate by remote control. (Refer to page 23.)

You can also perform Auto Tuning using GUI. (Refer to page 25.)

ARB7050

GUI MODE

FREQUENCY PRESETTING

MPX MODE

Switch off when the GUI MODE button is on.

1. Tune into the desired station.

See the section "TUNING INTO STATIONS".

In addition to station frequencies, the MPX MODE (auto

stereo mode or monaural mode) can also be preset (FM

only).

2. Press the MEMORY button.

The station (channel) number flashes in the display. (Memory

mode.)

3. Turn the MULTI-JOG to select the station (channel) you

want to memorize.

4. Press the MEMORY button.

÷ The station (channel) number lights in the display, indicating

that it has been memorized.

÷ If you do not press the MEMORY button within about five

seconds after selecting a station, the memory mode is

canceled.

5. Repeat steps 1 to 4 to preset additional stations.

A total of 30 AM and FM stations may be preset. When you

store a new preset, it takes the place of the previously stored

station (if any).

You can also preset using GUI. (Refer to page 25.)

LISTENING TO BROADCASTS USING

PRESET TUNING

Switch off when the GUI MODE button is on.

1. Press the SELECT button.

The "ST CALL" indicator lights in the display and the mode

switches to station call.

2. Turn the MULTI-JOG to select a station.

3. Adjust the volume and tone as desired.

When operating by remote control, press the ST +/– buttons to

select a memorized station. (Refer to page 23.)

With GUI, you can also select preset channels. (Refer to page 25.)

2, 4

GUI MODE