Pioneer GM5400T - Bridgeable Amplifier Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Pioneer GM5400T - Bridgeable Amplifier. Pioneer GM5400T - Bridgeable Amplifier 17 halaman. Bridgeable two-channel power amplifier
Juga untuk Pioneer GM5400T - Bridgeable Amplifier: Panduan Pemilik (41 halaman), Panduan Pemilik (48 halaman), Panduan Pemilik (17 halaman), Panduan Servis (29 halaman)

Pioneer GM5400T - Bridgeable Amplifier Panduan Pemilik
( Installation
)
---------------~/
section
(
),.
~.-----------~/~
Before installing the amplifier
AWARNING
To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
down.
Do not install in:
-
Places where it could injure the driver or
passengers if the vehicle stops suddenly.
-
Places where it may interfere with the dri-
ver, such as on the floor in front of the dri-
ver's seat.
Install tapping screws in such a way that the
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
Make sure that wires are not caught in the
sliding mechanism of the seats, resulting in a
short-ci rcu it.
When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake lines, wiring) from damage.
A
CAUTION
To ensure proper heat dissipation of the ampli-
fier, ensure the following during installation:
-
Allow adequate space above the amplifier
for proper ventilation.
-
Do not cover the amplifier with a floor mat
or carpet.
Avoid routing wires through hot areas, such
as near the heater outlet. Heat may damage
the insulation, resulting in a short-circuit
through the vehicle body.
• The optimal installation location differs de-
pending on the car model. Secure the ampli-
fier at a sufficiently rigid location.
Firstly make temporary connections and
check to ensure the amplifier and system op-
erate properly.
After installing the amplifier, confirm that the
_____ .1.: __
: __
1. __ -I L __ l ....
L
~I.
. .__
::>fJart: lIrt:,JaU\aIIU lUUI::> Lall ueea;:'IIY re-
moved.C!J
Example of installation on
the floor mat or chassis
1
Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm x
18 mm) into the screw holes and push on the
screws with a screwdriver so they make an im-
print where the installation holes are to be lo-
cated.
2
Drill 2.5 mm (1/8 inch) diameter holes
at the imprints either on the carpet or di-
rectly on the chassis.
3
Install the amplifier with the use of
supplied tapping screws (4 mm x 18 mm).
CD
Tapping-screws (4 mm x 18
mm)
@
Drill a 2.5 mm (1/8 inch) diameter hole
®
Floor mat or chassis
[!J
En
CID