Pioneer GM5400T - Bridgeable Amplifier 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Pioneer GM5400T - Bridgeable Amplifier에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM5400T - Bridgeable Amplifier 17 페이지. Bridgeable two-channel power amplifier
Pioneer GM5400T - Bridgeable Amplifier에 대해서도 마찬가지입니다: 소유자 매뉴얼 (41 페이지), 소유자 매뉴얼 (48 페이지), 소유자 매뉴얼 (17 페이지), 서비스 매뉴얼 (29 페이지)
페이지 인쇄
( Installation
)
---------------~/
section
(
),.
~.-----------~/~
Before installing the amplifier
AWARNING
•
To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
down.
•
Do not install in:
-
Places where it could injure the driver or
passengers if the vehicle stops suddenly.
-
Places where it may interfere with the dri-
ver, such as on the floor in front of the dri-
ver's seat.
•
Install tapping screws in such a way that the
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
•
Make sure that wires are not caught in the
sliding mechanism of the seats, resulting in a
short-ci rcu it.
•
When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake lines, wiring) from damage.
A
CAUTION
•
To ensure proper heat dissipation of the ampli-
fier, ensure the following during installation:
-
Allow adequate space above the amplifier
for proper ventilation.
-
Do not cover the amplifier with a floor mat
or carpet.
•
Avoid routing wires through hot areas, such
as near the heater outlet. Heat may damage
the insulation, resulting in a short-circuit
through the vehicle body.
• The optimal installation location differs de-
pending on the car model. Secure the ampli-
fier at a sufficiently rigid location.
•
Firstly make temporary connections and
check to ensure the amplifier and system op-
erate properly.
•
After installing the amplifier, confirm that the
_____ .1.: __
: __
1. __ -I L __ l ....
L
~I.
. .__
::>fJart: lIrt:,JaU\aIIU lUUI::> Lall ueea;:'IIY re-
moved.C!J
Example of installation on
the floor mat or chassis
1
Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm x
18 mm) into the screw holes and push on the
screws with a screwdriver so they make an im-
print where the installation holes are to be lo-
cated.
2
Drill 2.5 mm (1/8 inch) diameter holes
at the imprints either on the carpet or di-
rectly on the chassis.
3
Install the amplifier with the use of
supplied tapping screws (4 mm x 18 mm).
CD
Tapping-screws (4 mm x 18
mm)
@
Drill a 2.5 mm (1/8 inch) diameter hole
®
Floor mat or chassis
[!J
En
CID