Pioneer VSP-200 Panduan Petunjuk Pengoperasian - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat Pioneer VSP-200. Pioneer VSP-200 15 halaman. Av surround processor/amplifier
Halaman Cetak
TROUBLE SHOOTING
|
Incorrect operations are often mistaken
for trouble and malfunctions.If you think that there is something wrong with this
cormponent,check the points below.Sometimes the trouble may Hie in another component inverstigate the other components and
electrical appliances being used
if the trouble cannot be rectified even after exercising the checks listed below.ask your nearest PIONEER authorized service
center or your dealer to carry out repair work.
Symptom
Cause
Remedy
when POWER switch is pressed.
:
*instances are rare, but the ploblem may be
¢Unplug the power cord of the unit from
due to the operation of the protector circuit.
| the AC wall outlet, then plug it in again
Control was not possible regard-|*Static electrcity affected the unit when the air |*Unplug. the power cord of the unit from
less of what operation button was|
was dry,such as in winter.
the AC wail outlet, then plug it in again.
pressed.
elf static electricity is pronnounced, it is
recommended that you operate the unit
using the remote control unit.
No
sound
or
picture
are|*Connections are incorrect
*Consult pages 5-7 and perform connec
produced,even
when
the INPUT
tions correctly.
SELECTOR button is selected.
*VOLUME is turned down
*Raise volume.
Speaker connecting wires are disconnected
j*Connect wires to terminals securely.
from speaker terminals
*One or both of the input cords are
*Connect input cords securely.
disconnected
«Noise being picked up from this unit and other|«Stop using appliances generating
equipmentiespecially electrical appliances
noise or remove them from vicinity of
using motors or fluorescent lights)
the stereo equipment.
*MUTING is on,and the MASTER VOLUME
eSwitch MUTING off.
level is high
High noise level.
*Consult the VCR's operating
instructions,and connect antenna
correctly.
«You are attempting to watch a TV source us-
}*Disconnect the copy system
ing a VCR with copy system connections.
connection (TV tuner function will
In general, when copy system connections
operate).
are rnade,the VCR's TV tuner function ceases
to operate.For details,consult the operating
instructions of your VCR
TVsource cannot be seen when|«TVantenna is not connected to VCR, or con-
the VCR's TV tuner is used.
nections are faulty
No rear sound is produced.
le The SURROUND MODE selector button is set
j*Set correctly
incorrectly
lsThe REAR LEVEL is turned down
eAdjust the rear level with the remote
control unit's REAR LEVEL button,
*Speaker connecting wires are disconnected
—_|eConnect wires to terminals securely.
from REAR SPEAKERS terminals.
Remote
controi
does
not
|*Batteries are dead or no batteries in remote control | *!Nsert new batteries
~
work.
unit.
*Using with 7 meters and within 30
*Poor angie or too great a distance from the
degrees angle of the remote sensor
remote sensor window.
window,
*There is an obstacle between you and the
*Change your position or move the
remote sensor window.
obstacle.
*A fluorescent light is shining on the remote
| *Move so fluorescent light does not
sensor window.
shine directly on ampiifier's front panel
remote sensor window.
Abnormal
functioning of this unit may be caused by
lighting, static electricity, or other external interference. To re-
store normal operation,turn the power off and then on
13
again,or unpiug the AC power cord and then plug it in again.
<ARB1488>