Pioneer VSP-200 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Pioneer VSP-200. Pioneer VSP-200 15 stron. Av surround processor/amplifier

Drukuj stronę

TROUBLE SHOOTING

Incorrect operations are often mistaken

for trouble and malfunctions.If you think that there is something wrong with this

cormponent,check the points below.Sometimes the trouble may Hie in another component inverstigate the other components and

electrical appliances being used

if the trouble cannot be rectified even after exercising the checks listed below.ask your nearest PIONEER authorized service

center or your dealer to carry out repair work.

Symptom

Cause

Remedy

when POWER switch is pressed.

*instances are rare, but the ploblem may be

¢Unplug the power cord of the unit from

due to the operation of the protector circuit.

| the AC wall outlet, then plug it in again

Control was not possible regard-|*Static electrcity affected the unit when the air |*Unplug. the power cord of the unit from

less of what operation button was|

was dry,such as in winter.

the AC wail outlet, then plug it in again.

pressed.

elf static electricity is pronnounced, it is

recommended that you operate the unit

using the remote control unit.

sound

picture

are|*Connections are incorrect

*Consult pages 5-7 and perform connec

produced,even

when

the INPUT

tions correctly.

SELECTOR button is selected.

*VOLUME is turned down

*Raise volume.

Speaker connecting wires are disconnected

j*Connect wires to terminals securely.

from speaker terminals

*One or both of the input cords are

*Connect input cords securely.

disconnected

«Noise being picked up from this unit and other|«Stop using appliances generating

equipmentiespecially electrical appliances

noise or remove them from vicinity of

using motors or fluorescent lights)

the stereo equipment.

*MUTING is on,and the MASTER VOLUME

eSwitch MUTING off.

level is high

High noise level.

*Consult the VCR's operating

instructions,and connect antenna

correctly.

«You are attempting to watch a TV source us-

}*Disconnect the copy system

ing a VCR with copy system connections.

connection (TV tuner function will

In general, when copy system connections

operate).

are rnade,the VCR's TV tuner function ceases

to operate.For details,consult the operating

instructions of your VCR

TVsource cannot be seen when|«TVantenna is not connected to VCR, or con-

the VCR's TV tuner is used.

nections are faulty

No rear sound is produced.

le The SURROUND MODE selector button is set

j*Set correctly

incorrectly

lsThe REAR LEVEL is turned down

eAdjust the rear level with the remote

control unit's REAR LEVEL button,

*Speaker connecting wires are disconnected

—_|eConnect wires to terminals securely.

from REAR SPEAKERS terminals.

Remote

controi

does

not

|*Batteries are dead or no batteries in remote control | *!Nsert new batteries

work.

unit.

*Using with 7 meters and within 30

*Poor angie or too great a distance from the

degrees angle of the remote sensor

remote sensor window.

window,

*There is an obstacle between you and the

*Change your position or move the

remote sensor window.

obstacle.

*A fluorescent light is shining on the remote

| *Move so fluorescent light does not

sensor window.

shine directly on ampiifier's front panel

remote sensor window.

Abnormal

functioning of this unit may be caused by

lighting, static electricity, or other external interference. To re-

store normal operation,turn the power off and then on

again,or unpiug the AC power cord and then plug it in again.