Pioneer CLD-M401 Panduan Petunjuk Pengoperasian - Halaman 35
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemutar CD Pioneer CLD-M401. Pioneer CLD-M401 40 halaman. Multi-play cd cdv/ld player
Juga untuk Pioneer CLD-M401: Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (40 halaman)
Halaman Cetak
TROUBLESHOOTING
WHEN A LASERVISION DISC IS BEING PLAYED
SYMPTOM
CAUSE
REMEDY
5. Disc is rotating but there is no
picture.
The TV set is not turned on.
Wrong connections from player to TV.
Turn on TV.
@
Make correct connections.
6. Picture
continuously
moves
vertically.
properly.
@
Adjust verticathoid control on TV.
7. Particular
disc
does
not
playback
properly.
The
playback stops in the middle
of the disc program.
8. Sound
is
distorted.
unnatural
or
9. No
sound
output
during
playback.
of the screen image shakes.
10. During STILL playback, a part
The playing surface of the disc is dirty.
@
The disc is warped.
@
CX system is turned ON for disc which has
no mark.
@
STILL/STEP
playback is being performed.
Sound is output only during the normal play
mode.
The audio signals are not output
during other playback modes.
e
Use a soft cloth and lightly wipe off the dirt
from the surface of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
@
LD discs only
Put the disc into the protective envelope, then
place it on a flat desk top. Subsequently, place
a flat board e.g. glass plate on the disc, and
load it with about 4 ~ 5 kgs (about 10 Ibs). If it
is left in this state for one day, sometimes the
warp will be alleviated.
Heavy books
about 4 ~ 5 Kgs
(10 tbs)
—
Glass plate
aK
Protective
Glass plate
envelope
®@ Press D/A/CX to turn CX system OFF,
e@ Press PLAY/SEARCH
or PLAY/PAUSE to set
the player to normal play mode.
@
Even if the disc is a standard play disc, there
may be some cases in which a fully still image
cannot be obtained, but this does not mean
that the player or the disc is defective.
11. CHAPTER
SKIP, CHAPTER
PROGRAM
PLAY
and
CHAPTER NUMBER SEARCH
cannot be performed.
@
Disc in which
no chapter
numbers
are
recorded is loaded.
@
Press DISP to check if chapter number is
displayed.
12. Certain discs take too long to
search or are not searched.
@
It takes time to read the recorded code,
depending on the disc.
@
Press CLEAR and picture will appear.
{At this point, a slightly different scene from
that which
has been
searched
for may
appear.)
35
<VRB1070>