Pioneer CLD-M401 사용 설명서 - 페이지 35

{카테고리_이름} Pioneer CLD-M401에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer CLD-M401 40 페이지. Multi-play cd cdv/ld player
Pioneer CLD-M401에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

1. Features and Functions

TROUBLESHOOTING

WHEN A LASERVISION DISC IS BEING PLAYED

SYMPTOM

CAUSE

REMEDY

5. Disc is rotating but there is no

picture.

The TV set is not turned on.

Wrong connections from player to TV.

Turn on TV.

Make correct connections.

6. Picture

continuously

moves

vertically.

properly.

Adjust verticathoid control on TV.

7. Particular

disc

does

not

playback

properly.

The

playback stops in the middle

of the disc program.

8. Sound

distorted.

unnatural

9. No

sound

output

during

playback.

of the screen image shakes.

10. During STILL playback, a part

The playing surface of the disc is dirty.

The disc is warped.

CX system is turned ON for disc which has

no mark.

STILL/STEP

playback is being performed.

Sound is output only during the normal play

mode.

The audio signals are not output

during other playback modes.

Use a soft cloth and lightly wipe off the dirt

from the surface of the disc. If necessary,

moisten a cloth with diluted neutral detergent

to remove heavy dirt or fingerprints.

LD discs only

Put the disc into the protective envelope, then

place it on a flat desk top. Subsequently, place

a flat board e.g. glass plate on the disc, and

load it with about 4 ~ 5 kgs (about 10 Ibs). If it

is left in this state for one day, sometimes the

warp will be alleviated.

Heavy books

about 4 ~ 5 Kgs

(10 tbs)

—

Glass plate

Protective

Glass plate

envelope

®@ Press D/A/CX to turn CX system OFF,

e@ Press PLAY/SEARCH

or PLAY/PAUSE to set

the player to normal play mode.

Even if the disc is a standard play disc, there

may be some cases in which a fully still image

cannot be obtained, but this does not mean

that the player or the disc is defective.

11. CHAPTER

SKIP, CHAPTER

PROGRAM

PLAY

and

CHAPTER NUMBER SEARCH

cannot be performed.

Disc in which

no chapter

numbers

are

recorded is loaded.

Press DISP to check if chapter number is

displayed.

12. Certain discs take too long to

search or are not searched.

It takes time to read the recorded code,

depending on the disc.

Press CLEAR and picture will appear.

{At this point, a slightly different scene from

that which

has been

searched

for may

appear.)