Pioneer DEH-313 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemutar CD Pioneer DEH-313. Pioneer DEH-313 20 halaman. High power cd player with fm/am tuner

Halaman Cetak

STRUMENTS WITH THIS

PRODUCT WILL INCREASE |

EYE HAZARD.

Note:

¢ Do not disassemble the unit.

In case of trouble

When the unit does not operate pro-

perly, contact your dealer or the nearest

authorized PIONEER Service Station.

Connecting the Cnits

o r

vehicles with a 12-volt

attery and negative grounding. Before

installing it.in a.recreational vehicle, truck,

or bus, check the battery voltage.

To avoid shorts in the electrical system,

be sure to disconnect the battery © cable

before beginning installation.

After completing installation and wiring,

double check that there are no mistakes.

Re-install any parts removed from the car

during installation, then connect the

battery negative terminal.

Refer to the owner's manual for details on

connecting the various cords of the

power amp and other units, them make

connections correctly.

Secure the wiring with cable clamps or

adhesive tape. To protect the wiring,

wrap adhesive tape around them where

they lie against metal parts.

Route and secure all wiring so it cannot

touch any moving parts, such as the gear

shift, handbrake, and seat rails. Do not

route wiring in places that get hot, such

as near the heater outlet. If the insulation

of the wiring melts or gets torn, there is a

danger of the wiring short-circuiting to

the vehicle body.

Don't pass the orange lead through a hole

into the engine compartment to connect °

to the battery. This will damage the lead.

insulation and cause a very dangerous

short.

Do not shorten any leads. If you do, the

protection circuit may fail to work when it

should.

Never feed power to other equipment by

cutting the insulation of the power supply

lead of the unit and tapping into the lead.

The current capacity of the lead will be

exceeded, causing over heating.

When replacing fuses, be sure to use only

fuses of the rating prescribed on the fuse

holder.

Since a unique BPTL circuit is employed,

never wire so the speaker leads are

directly grounded or the left and right

Speakers connected to this unit must be

high-power type possessing maximum

input of at least 22 W and impedance of 4

to 8 ohms. Connecting speakers with

output and/or impedance values other

than those noted here can damage the

speakers.