Pioneer DEH-313 Kullanıcı El Kitabı - Sayfa 4
CD Çalar Pioneer DEH-313 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer DEH-313 20 sayfaları. High power cd player with fm/am tuner
STRUMENTS WITH THIS
=~
PRODUCT WILL INCREASE |
EYE HAZARD.
:
Note:
¢ Do not disassemble the unit.
In case of trouble
When the unit does not operate pro-
perly, contact your dealer or the nearest
authorized PIONEER Service Station.
.
Connecting the Cnits
o r
vehicles with a 12-volt
attery and negative grounding. Before
installing it.in a.recreational vehicle, truck,
or bus, check the battery voltage.
To avoid shorts in the electrical system,
be sure to disconnect the battery © cable
before beginning installation.
After completing installation and wiring,
double check that there are no mistakes.
Re-install any parts removed from the car
during installation, then connect the
battery negative terminal.
Refer to the owner's manual for details on
connecting the various cords of the
power amp and other units, them make
connections correctly.
Secure the wiring with cable clamps or
adhesive tape. To protect the wiring,
wrap adhesive tape around them where
they lie against metal parts.
Route and secure all wiring so it cannot
touch any moving parts, such as the gear
shift, handbrake, and seat rails. Do not
route wiring in places that get hot, such
as near the heater outlet. If the insulation
of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to
the vehicle body.
.
.
Don't pass the orange lead through a hole
into the engine compartment to connect °
to the battery. This will damage the lead.
insulation and cause a very dangerous
short.
Me
Do not shorten any leads. If you do, the
protection circuit may fail to work when it
should.
Never feed power to other equipment by
cutting the insulation of the power supply
lead of the unit and tapping into the lead.
The current capacity of the lead will be
exceeded, causing over heating.
When replacing fuses, be sure to use only
fuses of the rating prescribed on the fuse
holder.
Since a unique BPTL circuit is employed,
never wire so the speaker leads are
directly grounded or the left and right
speaker © leads are common.
Speakers connected to this unit must be
high-power type possessing maximum
input of at least 22 W and impedance of 4
to 8 ohms. Connecting speakers with
output and/or impedance values other
than those noted here can damage the
speakers.