Pioneer S-VSL6C Panduan Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem Pembicara Pioneer S-VSL6C. Pioneer S-VSL6C 13 halaman. Pioneer s-vsl6c: operating instruction
Juga untuk Pioneer S-VSL6C: Petunjuk Pengoperasian (4 halaman)
![Pioneer S-VSL6C Panduan Pengoperasian](/uploads/products/server2/6637216/6637216.png)
Confirm your Accessories
• Speaker stand
• Speaker wire
• Speaker stand
mounting pads (3 types)
• Screws (7)
• Self-adhering fastener
(hook strip) x2
• Operating Instructions
Connecting Speakers to Amplifier
1Disconnect the power cord to the amplifier.
2Use the provided accessory speaker wire to connect the
input terminals on the rear panel of the speakers to the
amplifier's speaker output terminals.
Connect the ª terminal to the wire with the white line;
connect the · terminal to the solid-color wire.
1. Remove insulation at end of wire
and twist ends of wire strands.
2. Loosen the terminal screw and
insert the twisted wire into the
hole, then tighten the terminal screw securely.
When using the supplied speaker stand in a horizontal
installation, pass the speaker wire through the speaker stand
before connecting. When mounting vertically, pass the wires
through the mounting fixture before connecting.
<Horizontal Installation>
Solid color wire; to
amplifier's · speaker
output terminal.
2
En
• Mounting
fixture
• Safety wire
• Anti-slip pads
• Washers (2)
• Self-adhering fastener
(loop strip) x2
<Vertical Installation>
Black ·
Stereo wire with white
Red ª
line; to amplifier's
speaker output ª
terminal
I The speaker system's input terminals can also be
connected using a banana plug (only with
horizontal installation)
• After connecting the wires to their speaker system
terminals, pull gently on the wires and confirm that the
leads are fastened securely to their terminals. Insecure
connections will result in broken sound and noise.
• Do not allow bare wire ends to protrude excessively from
the terminals. If bare wires from the two leads touch each
other, excessive load will be placed on the amplifier, leading
to possible damage or malfunction.
• Be sure to connect the + and – leads to their correct
terminals. If the poles at one end of the wires are
connected mistakenly (+ to –, – to +), proper stereo effect
will not be produced.
Rack Installation
Preparation
When mounting the speakers on a rack, use the supplied
accessory anti-slip pad or self-adhering fastener strips. The
anti-slip pads may not be fully effective on some surfaces; if
any danger of tipping or falling exists, do not attempt to
mount the speakers in that position.
• Using anti-slip pads
Peel off the protective paper backing from the four anti-slip
pads and apply to the four bottom corners of the speaker
stand.
Anti-slip pads
• Using self-adhering fastener
1. Peel off the protective paper backing from the two loop
strips and apply to the bottom surface of the speaker
stand.
2. Peel off the protective paper backing from the two hook
strips and apply to the surface of the installation surface
in alignment with the two loop strips on the speaker
stand.
Self-adhering fastener
(loop strip)
Self-adhering fastener
(hook strip)
Installation
surface