- ページ 2

スピーカーシステム Pioneer S-VSL6CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer S-VSL6C 13 ページ。 Pioneer s-vsl6c: operating instruction
Pioneer S-VSL6C にも：操作説明 (4 ページ)

ページを印刷する

Confirm your Accessories

• Speaker stand

• Speaker wire

• Speaker stand

mounting pads (3 types)

• Screws (7)

• Self-adhering fastener

(hook strip) x2

• Operating Instructions

Connecting Speakers to Amplifier

1Disconnect the power cord to the amplifier.

2Use the provided accessory speaker wire to connect the

input terminals on the rear panel of the speakers to the

amplifier's speaker output terminals.

Connect the ª terminal to the wire with the white line;

connect the · terminal to the solid-color wire.

1. Remove insulation at end of wire

and twist ends of wire strands.

2. Loosen the terminal screw and

insert the twisted wire into the

hole, then tighten the terminal screw securely.

When using the supplied speaker stand in a horizontal

installation, pass the speaker wire through the speaker stand

before connecting. When mounting vertically, pass the wires

through the mounting fixture before connecting.

Solid color wire; to

amplifier's · speaker

output terminal.

• Mounting

fixture

• Safety wire

• Anti-slip pads

• Washers (2)

• Self-adhering fastener

(loop strip) x2

Black ·

Stereo wire with white

Red ª

line; to amplifier's

speaker output ª

terminal

I The speaker system's input terminals can also be

connected using a banana plug (only with

horizontal installation)

• After connecting the wires to their speaker system

terminals, pull gently on the wires and confirm that the

leads are fastened securely to their terminals. Insecure

connections will result in broken sound and noise.

• Do not allow bare wire ends to protrude excessively from

the terminals. If bare wires from the two leads touch each

other, excessive load will be placed on the amplifier, leading

to possible damage or malfunction.

• Be sure to connect the + and – leads to their correct

terminals. If the poles at one end of the wires are

connected mistakenly (+ to –, – to +), proper stereo effect

will not be produced.

Rack Installation

Preparation

When mounting the speakers on a rack, use the supplied

accessory anti-slip pad or self-adhering fastener strips. The

anti-slip pads may not be fully effective on some surfaces; if

any danger of tipping or falling exists, do not attempt to

mount the speakers in that position.

• Using anti-slip pads

Peel off the protective paper backing from the four anti-slip

pads and apply to the four bottom corners of the speaker

stand.

Anti-slip pads

• Using self-adhering fastener

1. Peel off the protective paper backing from the two loop

strips and apply to the bottom surface of the speaker

stand.

2. Peel off the protective paper backing from the two hook

strips and apply to the surface of the installation surface

in alignment with the two loop strips on the speaker

stand.

Self-adhering fastener

(loop strip)

Self-adhering fastener

(hook strip)

Installation

surface