Aeotec Smart Switch 7 Manual - Halaman 13
Jelajahi secara online atau unduh pdf Manual untuk Beralih Aeotec Smart Switch 7. Aeotec Smart Switch 7 18 halaman.
Juga untuk Aeotec Smart Switch 7: Panduan Pengguna (8 halaman), Manual (6 halaman)
Halaman Cetak
4.6
Version
Parameter
Z-Wave Protocol Library Type 0x03
Z-Wave Protocol Version
Z-Wave Protocol Sub Version
Firmware 0 Version
Firmware 0 Sub Version
Hardware Version
Number of firmware targets
4.7
Notification
Notification Type
Power Management 0x08
System
0x09
4.8
Protection
4.8.1
Protection Supported Report
Parameter
Local Protection State Byte 1 0x05
Local Protection State Byte 2 0x00
RF Protection State Byte 1
RF Protection State Byte 2
Exclusive Control
Timeout
4.8.2
Protection Set
Parameter
Local Protection State Byte
RF Protection State Byte
Note:
(1) Regardless of the state of the product, when over-current or over-load detected, it will automatically TURN OFF
switch and set Local Protection State to be 2 and RF Protection State to be 1, and start red light blinking. Users can't
manually or RF control the switch state until setting the Protection State to be unprotected through the Gateway or
Controller, even power off will still keep Protection State.
AEOTEC Engineering Specification
Value
0x06
0x04
ZM5101 Software Version MSB
ZM5101 Software Version LSB
0xAF
0x00
Notification Events
State idle
Over-current detected
Over-load detected
State idle
System hardware failure (manufacturer
proprietary failure code provided)
Value
0x03
0x00
0x00
0x00
Value
Function
Unprotected. The device is not protected, and may be operated normally via the
0
user interface.
No operation possible. It is not possible at all to control a device directly via the
2
user interface.
0
Unprotected. The device MUST accept and respond to all RF Commands.
No RF control - all runtime Commands are ignored by the device. The device
1
MUST still respond with status on requests.
Description
0x00
Idle
0x06
Current is over 11A.
0x08
Power is over the threshold value.
0x00
N/A
0x03
Event/State Parameter=0x01:
Built-in unrecoverable temperature fuse
has detected the internal temperature
exceeds the limit and disconnect. It also
means that the product has damaged if
this notification is sent out.
Page 8