Ariston FM 53 F (ALU) Panduan Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Oven Ariston FM 53 F (ALU). Ariston FM 53 F (ALU) 8 halaman.

Halaman Cetak

Technical instructions for installation and adjustment.

for the sole use of specialised installers

The instructions which follow are to help the qualified installer

carry out operations in the most correct way in compliance

with the regulations in force.

IMPORTANT

Any adjustment, etc. must be carried out with the oven

disconnected from the electricity supply. Whenever it is

necessary to carry out maintenance work with the appliance

connected to the power supply, maximum precautions should

be taken.

Built in installation

For correct operation of the oven built into a kitchen unit or

other housing section, the latter must be suitable.

The characteristics of the housing section and instructions

for fitting in and assembling are given below (Fig. 7).

Protection against contact with electrical parts, in compliance

with current regulations, must be ensured by correct building-

in of the appliance.

All parts which guarantee protection, even any covering panel

(for example if an appliance is located at the end or beginning

of the modular units), must be fixed in such a way that it

cannot be removed without tools. It should be noted that heat-

resistant glues (90°C) must be used to bond together the

layers of plastic material and veneered wood in housing units

for built-in appliances.

Unsuitable plastic materials or glues that are not heat-

resistant are the cause of warping and ungluing.

Fitting onto base unit

The housing section must have the dimensions shown in

the figures and be fitted with supports allowing efficient

circulation of cooling air (Fig.8).

Suitable air intakes (Fig. 9) should be provided for efficient

ventilation on the bottom front part and the top part of the

appliance: bottom inlet of at least 200 cm

least 120 cm

Installation into tall housing unit

The housing section must have the dimensions shown in

the figures and be fitted with supports allowing efficient

circulation of cooling air (Fig.8), It is also essential that the

oven is fitted with a ventilation pipe as shown in fig. 10. If the

housing unit reaches the ceiling, it is indispensable to connect

an adequate channel to the ventilation pipe to convey air

outdoors.

Fixing onto base or tall housing unit

Insert the appliance into the housing section; open the oven

door and fix the oven to the kitchen unit using the four self-

screwing screws provided, placing the relative spacers "A"

placed in the four holes to be found on the outer frame (fig.11)

between the housing unit and the oven.

INSTALLATION INSTRUCTIONS

, top outlet of at

FIGURE 8

FIGURE 10

(Fig. 7)

FIGURE 9

FIGURE 11