Whirlpool CATALYST Panduan Pemecahan Masalah & Perbaikan - Halaman 26
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah & Perbaikan untuk Mesin cuci Whirlpool CATALYST. Whirlpool CATALYST 45 halaman. Electronic three-speed automatic washers with catalyst cleaning action
Juga untuk Whirlpool CATALYST: Panduan Penggunaan dan Perawatan (15 halaman)
Halaman Cetak
Removing the Out-of-Balance Switch
The Out-of-Balance Switch is located on the inside surface of the feature panel.
1.
Reach into the bottom of the plastic protective cover of the Out-of-Balance Switch and discon-
nect the wiring harness plug from the switch terminals.
2.
Remove the hex-head screw on the outside surface of the feature panel. (Fig. 12)
3.
Slide the Out-of-Balance Switch so the tabs of the mounting bracket disengage from the key
slots as show in Figure 12 and remove the switch assembly.
NOTE: The Service Replacement Out-of-Balance Switch is equipped with a clear
plastic protective cover. This MUST be installed with the switch. (Fig. 13)
Fig. 12
SLIDE TO LEFT TO
DISENGAGE TABS
Servicing the Catalyst Cleaning Action™ Recirculation System
Figure 17 illustrates the various components of the Catalyst Cleaning Action™ recirculation system.
These components are:
•
Pump
•
Diverter Valve
•
Recirculation Pressure Dome
•
Recirculation Pressure Switch
•
Recirculation Spray Inlet (part of Tub Ring)
SCREW
22
Fig. 13