Whirlpool CATALYST 문제 해결 및 수리 매뉴얼 - 페이지 26

{카테고리_이름} Whirlpool CATALYST에 대한 문제 해결 및 수리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CATALYST 45 페이지. Electronic three-speed automatic washers with catalyst cleaning action
Whirlpool CATALYST에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (15 페이지)

페이지 인쇄

Removing the Out-of-Balance Switch

The Out-of-Balance Switch is located on the inside surface of the feature panel.

Reach into the bottom of the plastic protective cover of the Out-of-Balance Switch and discon-

nect the wiring harness plug from the switch terminals.

Remove the hex-head screw on the outside surface of the feature panel. (Fig. 12)

Slide the Out-of-Balance Switch so the tabs of the mounting bracket disengage from the key

slots as show in Figure 12 and remove the switch assembly.

NOTE: The Service Replacement Out-of-Balance Switch is equipped with a clear

plastic protective cover. This MUST be installed with the switch. (Fig. 13)

Fig. 12

SLIDE TO LEFT TO

DISENGAGE TABS

Servicing the Catalyst Cleaning Action™ Recirculation System

Figure 17 illustrates the various components of the Catalyst Cleaning Action™ recirculation system.

These components are:

•

Pump

•

Diverter Valve

•

Recirculation Pressure Dome

•

Recirculation Pressure Switch

•

Recirculation Spray Inlet (part of Tub Ring)

SCREW

Fig. 13