Firenzo HASTINGS 4.8KW Petunjuk Untuk Manual Instalasi - Halaman 17
Jelajahi secara online atau unduh pdf Petunjuk Untuk Manual Instalasi untuk Kompor kayu Firenzo HASTINGS 4.8KW. Firenzo HASTINGS 4.8KW 19 halaman. 4.8kw free standing wood burning stove
Halaman Cetak9.2 Internal maintenance
9.2.1 Glass window
If the stove is used correctly, very little or no soot will be deposited on the ceramic glass window. If soot does
form on the glass as the stove is being lit, it will burn away once normal combustion begins in the stove. If the
glass window becomes thoroughly covered in soot due to incorrect operation, the soot can be easily removed
using an approved glass cleaner. The glass must be cold when you clean it. Avoid stoking the stove with pieces
of wood that are so long that they press against the glass window when the door is closed.
9.2.2 Reasons for sooty glass window:
- The fuel is too wet.
- The pieces of fuel are to big/uncut wood.
- The combustion temperature is too low.
- Insufficient air for the combustion.
9.2.3 Ceramic glass replacement
Only replace with genuine Firenzo Robax™ glass.
Ceramic glass cannot be recycled because it has a higher melting point that ordinary glass.
If ceramic glass is mixed with ordinary glass, the raw material is spoiled, and the reclaiming process may be
halted. Take care that the ceramic glass does not end up among ordinary recycled waste. That will be a great
benefit to the environment.
Note: Should be handed in to a recycling station as ceramic glass.
9.2.4 Refractory linings
Only replace with genuine Firenzo parts.
The base of the fire uses our special Firenzo refractory kiln bricks.
The sides, back and baffle of the fire uses Firenzo Scamolex™ bricks.
The condition of the refractory linings needs to be checked annually by your chimney sweep and replaced if
signs of deterioration are evident.
9.2.5 Air supply components
Only replace with genuine Firenzo parts.
Air supply components are made from steel and/or high temperature bearing stainless steel and need to be
checked annually by your chimney sweep and replaced if signs of deterioration are evident.
9.2.6 Gaskets
Only replace with genuine Firenzo parts.
Over time, the gaskets and seals around the stove will wear and should be replaced as needed in order to
prevent uncontrolled combustion. Use only the original Firenzo seals and gaskets.
9.2.7 General
Reasons for overly rapid wear of internal parts
- Stove fired too vigorously
- Use of very dry wood (wood from old furniture).
- Too much soot on top of the baffles (please see the section on Cleaning).
- Too much ash in the ash pan (please see the section on Ash).
Please note that no unauthorised alterations of the design may be undertaken, and that any parts that are
replaced must be replaced with genuine original Firenzo parts. Failure to comply may render the
warranty invalid.
9.3 Cleaning the stove/chimney
It is important that the stove is regularly maintained by a competent engineer and that the whole system (stove,
flue connector and flue) are cleaned regularly.
In particular on the topside of the baffle bricks, layers of ashes and soot will form as a result of the chimney draft
and after a sweep.
The baffle bricks may be taken out of the stove under normal cleaning.
Removing the baffle bricks:
HI-2014-06-09
17