Whirlpool 27" W10563341A Panduan Petunjuk Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool 27" W10563341A. Whirlpool 27" W10563341A 20 halaman. Electric dryer 27" wide models

Halaman Cetak

1. Troubleshooting

Connect external ground wire

Connect a separate copper ground wire (G) from the external

ground conductor screw (A) to an adequate ground. Finally, reinsert

tab of terminal block cover into slot of dryer rear panel. Secure

cover with hold-down screw. Now, go to Venting Requirements.

VENTING

Venting Requirements

WARNING:

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT:

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace, or a concealed space

of a building. Only rigid or flexible metal vent shall be used for

exhausting.

4" (102 mm) heavy metal exhaust vent

Only a 4" (102 mm) heavy metal exhaust vent and clamps

■

may be used.

Do not use plastic or metal foil vent.

■

(102 mm)

Rigid metal vent:

Recommended for best drying performance and to avoid

■

crushing and kinking.

Flexible metal vent:

(Acceptable only if accessible to clean)

Must be fully extended and supported in final dryer location.

■

Remove excess to avoid sagging and kinking that may result

■

in reduced airflow and poor performance.

Do not install in enclosed walls, ceilings, or floors.

■

The total length should not exceed 7

■

NOTE:

If using an existing vent system, clean lint from entire

length of the system and make sure exhaust hood is not plugged

with lint. Replace plastic or metal foil vents with rigid metal or

flexible metal vents. Review Vent System Chart and if necessary,

modify existing vent system to achieve best drying performance.

Exhaust hoods:

Must be at least 12" (305 mm) from ground or any object that

■

may obstruct exhaust (such as flowers, rocks, bushes, or

snow).

Recommended Styles:

Louvered hood

Acceptable Style:

Angled hood

Elbows:

45° elbows provide better airflow than 90° elbows.

■

Good

ft. (2.4 m).

Box hood

Better