Whirlpool 3396311 Panduan Penggunaan dan Perawatan - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Pengering Whirlpool 3396311. Whirlpool 3396311 23 halaman. Whirlpool electric and gas drvers use and care 3396311

Halaman Cetak

PROBLEM

CHECK IF

Shrlnklng

Items are overdried

C IAUSE~~LUTI~NS

Remove ittlms while there is still a trace

of moisture. Some items should be

removed w bile damp, then shaped and air

dried.

Slow drying

Fabric type and quality is

suitable for drying

There is a large amount of

moisture in the load to be

dried

Some knits are stretched during manufac-

turing. Washing and drying returns them

to the original size. This is normal. Check

quality of g arment before buying. Follow

fabric care label directions carefully.

Some item!;; hold more moisture than

others (cotlons more than polyester).

They take I :)nger to dry. Full loads take

longer to dr!r than small loads of the same

fabric.

Cold rinse water is used

A load rinslt~d in cold water will take

slightly lon!;ier to dry than a warm one.

Cold rinses, however, help save energy

and reduce wrinkling more than warm

rinses do.

Room air temperature is

below 45°F (7°C)

Install dryer in a room where the air

temperatun

is warmer than 45OF (7°C).

Cold air inc eases drying time and may

cause wrinC les not to be removed.

Dryer is exhausted according

to Installation Instructions

Lint screen is clogged

Install and t lxhaust your dryer according

to the Installation Instructions provided.

Clean lint .s::reen before or after

each use.

Exhaust duct or outside

exhaust hood is clogged

Proper electrical supply is

used

Clean if net+ded.

Properly col'lnect the dryer to a grounded

electrical circuit that meets the electrical

requiremenis stated in the Installation

Instructions

Static

electrktty

Load is overdried

Fabric soflener is used

Remove itelns while there is still a trace

of moisture.

Use a fabric: softener and follow package

directions c: Irefully.

Synthetics, synthetic blends,

permanent press and knits are

Synthetics, ilynthetic blends, permanent

press and khlts build up static electricity.

in load

Use a fabric softener and be careful not to

overdry the load.