Whirlpool AWD60A Panduan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengering Whirlpool AWD60A. Whirlpool AWD60A 32 halaman. Tumble dryer
Juga untuk Whirlpool AWD60A: Panduan Pengoperasian (16 halaman), Panduan Servis (22 halaman)

Whirlpool AWD60A Panduan Pengoperasian

RACK FITTING INSTRUCTIONS

To hold the drying rack out of the way
when not in use, it will be necessary to
attach the retaining clip to the base of
your dryer.
To do this, firstly remove the screw located
4cm from the right corner of the inverted
dryer (Fig. 3).
Then position the retaining clip over the
hole so that the prong on the clip is near
the cabinet corner and faces outwards
(Fig. 4).
Tighten clip using the same screws. Repeat this on the left side.
Fit drying rack to its cabinet mountings. Tilt rack upwards and align retaining clip until rack
frame "snaps" into prong clip (Fig. 4).
To make use of the drying rack, firstly rotate
the outlet grill so that the louvers point
towards the rack.
Place items to be dried at the centre of the
Shoes should be placed upside down.
A large woollen article eg. a cardigan, should
be placed over the whole rack, and to ensure
more even drying will need rearranging from
time to time.
Caution:
1. The maximum weight should not exceed 1kg.
2. Make sure the clothes are suitable for the dryer.
3. As the exhaust air temperature rises at the end of a normal drying cycle, it is important that
you regularly check items on the rack to make sure they are not overheated.
10
TumbleDryer_AWD60A-4.indd 10
Remove
screw
FIG. 3.
Retaining
clip
Drying
rack
FIG. 4.
5/8/08 4:26:01 PM