Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan - Halaman 10

Halaman Cetak

Whirlpool Cabrio,- WED7300X Panduan Penggunaan dan Perawatan

Select cycle options

Select any other cycle options you may wish to add, if not

previously set. Some cycles will automatically add certain

options such as Deep Clean or Extra Rinse. These can be

turned off, if desired.

NOTE: Not all options are available with all cycles.

10.

Press START/Pause/Unlock to

begin wash cycle

Press the START/Pause/Unlock button to start the wash cycle.

When the cycle has finished, the DONE indicator will light and

the end of cycle signal will sound (if set).

Promptly remove garments after cycle has completed to

avoid odor, reduce wrinkling, and rusting of metal hooks,

zippers, and snaps.

Unlocking the lid to add garments:

If you need to open the lid to add 1 or 2

missed garments:

Press START/Pause/Unlock; the lid will unlock

once the washer movement has stopped.

This may take several minutes if the load

was spinning at high speed. Then close

lid and press START/Pause/Unlock again

to restart the cycle.

If lid is left open for more than 10 minutes the water will

pump out automatically.

WASHER MAINTENANCE

WATER INLET HOSES

Replace inlet hoses after 5 years of use to reduce the risk

of hose failure. Periodically inspect and replace inlet hoses

if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of

replacement on the label with a permanent marker.

CLEANING YOUR WASHER

Keep your washer as clean and fresh as your clothes.

To keep washer interior odor-free, follow this recommended

monthly cleaning procedure:

1. Make sure the washer is empty.

2. Using recommended AFFRESH

add one tablet to washer drum

If using liquid chlorine bleach, add 1 cup (250 mL) to

liquid chlorine bleach dispenser.

IMPORTANT: Do not add detergent to CLEAN WASHER

with AFFRESH

cycle. Do not use more than recommended

™

amount of bleach to avoid damaging product over time.

3. Close washer lid.

4. Press POWER.

5. Select CLEAN WASHER with AFFRESH

6. Press START/PAUSE. Water will pour into washer

for a moment and pause, lid will lock, then cycle

will continue.

NOTE: For best results, do not interrupt cycle. If cycle must

be interrupted, press START/Pause/Unlock twice and run

a RINSE AND SPIN cycle to ensure cleaner or bleach have

been rinsed from washer.

To clean exterior:

1. Use a soft, damp cloth or sponge to wipe up any spills.

2. Use all-purpose surface cleaner, if needed.

IMPORTANT: To avoid damaging the washer's finish,

do not use abrasive products.

washer cleaner,

cycle.

™