Whirlpool Cabrio,- WED7300X Panduan Penggunaan & Perawatan - Halaman 15

Halaman Cetak

Whirlpool Cabrio,- WED7300X Panduan Penggunaan & Perawatan

Troubleshooting

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -

If you experience

Washer not performing as expected (cont.)

Washer won't run or ll,

washer stops working

(cont.)

Washer not draining/

spinning, loads are still

wet

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

Possible Causes

Check proper electrical supply.

Normal washer operation.

Washer may be tightly packed.

Not using HE detergent or using too

much HE detergent.

Empty pockets and use garment

bags for small items.

Using cycles with a lower spin speed. Cycles with lower spin speeds remove less water than cycles

Washer may be tightly packed or

unbalanced.

Check plumbing for correct drain

hose installation. Drain hose extends

into standpipe farther than 4.5"

(114 mm).

Plug power cord into a grounded 3-prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not

interrupt cycle.

Washer may be stopped to reduce suds.

Remove several items, rearrange load evenly around the

washplate. Close lid and press START/PAUSE.

Add only 1 or 2 additional items after washer has started.

Do not add more water to the washer.

Only use HE detergent. Suds from regular detergents can slow

or stop the washer. Always measure detergent and following

detergent directions based on your load requirements.

To remove suds, cancel cycle. Select RINSE & SPIN. Select your

cycle. Press START/PAUSE. Do not add more detergent.

Small items may have been caught in pump or between basket

and tub, which can slow draining.

with high spin speeds. Use the recommended cycle/speed spin

for your item.

Tightly packed loads may not allow the washer to spin correctly,

leaving the load wetter than normal. Evenly arrange the wet load

for balanced spinning. Select RINSE & SPIN to remove excess

water. See "Using Your Washer" for loading recommendations.

Check drain hose for proper installation. Use drain hose

form and securely attach to drainpipe or tub. Do not tape

over drain opening. Lower drain hose if the end is higher than

96" (2.4 m) above the oor. Remove any clogs from drain hose.

Solution