Whirlpool YGEW9250PL0 Panduan Penggunaan & Perawatan - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Pengering Whirlpool YGEW9250PL0. Whirlpool YGEW9250PL0 40 halaman. Electronic electric dryer

Halaman Cetak
DRYER USE
Statu_
Controt
O_
0 s_lJsin_
_
Heavy DMy,
v
0
Wel
NormaJ
0 _p
OM_re
Bulky.
0 H_h
OCooJ......
I00
Items
More
Ohme
OMediurn
0
(yde
Complete
OLess
C02UQ]"
'Tim¢d
Sty
P_ds_
0
Low
Less @
Cgncel
0 W#nkle S hield
Delicatl
"ouchUp
hme
Dryness
0 Extra Low
0
Co_volLocked
Level
Ouick
Dry
Manual Cycles
0 On
0 Air Only
j;J
©
©
_"
_/rinkle ShieM
Temperature
_
(Monu_]
Cycles o_¢y)
_,
"--._
O Louder
0 So_er
o off
©
End Of _cie Signal
J
Explosion
Hazard
Keep flammabme materiams and vapors,
such as
gasoline,
away from dryer.
Do not dry anything
that has ever had anything
flammabBe on it (even after washing).
Failure to follow
these instructions
can result in death,
explosion,
or fire.
Fire Hazard
No washer can compmetemy remove oil.
Do not dry anything
that has ever had any type of oH on
it (incmuding cooking
oils).
Items containing
foam, rubber,
or pBastic must be dried
on a cmothesffne or by using an Air Cycme.
Failure to follow
these instructions
can result in death
or fire.
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
The following is a guide to starting your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before or after each cycle. See "Cleaning
the Lint Screen."
2. Place laundry into dryer and shut door. See "Loading."
3. Rotate the dial to select either an Automatic or Manual Cycle
then press the CONTROL ON button. The preset settings and
drying time for the cycle chosen will be displayed.
To use an Automatic
Cycle
Point the dial to an Automatic Cycle.
Select DRYNESS LEVEL to adjust how dry you want the
load to be. The time displayed is an estimated length of
the cycle based on the Dryness Level selected. As the
cycle runs, the control senses the dryness of the load and
adjusts the time automatically for the selected Dryness
Level.
0 More
0
0 Less
©
Dryness
Level
NOTE: Time is not adjustable for Automatic
Cycles. Pressing
the More Time or Less Time buttons will cause a triple beep,
indicating that the time cannot be changed.
Press the WRINKLE SHIELD
TM
feature button if this
option is desired.
Press the END OF CYCLE SIGNAL button to set signal
volume to desired level.
Press (and hold) HOLD TO START button until dryer starts
(about 1 second).
Once an Automatic
cycle has started, the WRINKLE
SHIELD
TM
feature and cycle signals can be adjusted. Press
the PAUSE/CANCEL key twice to stop the dryer and clear the
settings, allowing you to select another cycle and Dryness
Level.
11