ABB FDNA-01 Panduan Instalasi dan Start-Up Cepat
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Start-Up Cepat untuk Unit Kontrol ABB FDNA-01. ABB FDNA-01 2 halaman. Canopen adapter module
Juga untuk ABB FDNA-01: Panduan Instalasi dan Start-Up Cepat (2 halaman)
Halaman Cetak
—
OPTIONS FOR ABB DRIVES
FDNA-01 DeviceNet adapter module
Quick installation and start-up guide
Safety instructions
WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or
damage to the equipment can occur.
Mechanical installation
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m
using a Torx TX10 screwdriver.
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can
damage the screw or module. A loose screw decreases the EMC performance, and can
cause an operation failure.
Electrical installation
Layout of the module
1
2
3
No.
Description
1
Lock
2
Mounting and grounding screw
3
Bus connector [X1]
4
Diagnostic LEDs
4
1
3
4