Whirlpool UXT4030AD Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan untuk Kap Ventilasi Whirlpool UXT4030AD. Whirlpool UXT4030AD 28 halaman. 30" and 36" (76.2 and 91.4 cm) range hood
Juga untuk Whirlpool UXT4030AD: Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan (24 halaman), Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan (24 halaman), Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan (24 halaman), Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan (24 halaman)

NOTES:

Depending on your model, determine which venting method

to use: roof, wall or non-vented (recirculating).

It is recommended that the vent system be installed before

the range hood is installed. Go to "Venting System" in the

"Installation Requirements" section if you need assistance.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for the vent system.

1. Disconnect power

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

2. Mark Hole Locations

Align the exterior edge of the mounting brackets with the exterior

edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

INSTALLATION INSTRUCTIONS

3. Install Brackets

Using a #2 Phillips screwdriver, install the drywall anchors.

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, it is

recommended that a qualified contractor determine the

anchoring method.

Set the range hood on its back on a covered surface.

Using a #2 Phillips screwdriver, remove the rectangular

damper attached with 3.5 x 9.5 mm screws.

Using a #2 Phillips screwdriver, remove the electrical box

cover.

Using a flat-blade screwdriver, remove the appropriate power

supply knockout.