Ergo In Demand KTG-230 Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Rak dan Dudukan Ergo In Demand KTG-230. Ergo In Demand KTG-230 8 halaman. Horizontal and vertical table stands and accessories

Halaman Cetak

Installation Instructions

Phillips Pan Head Screw

(170 or 180)

Spacer

(190 or 200)

Figure 11: Mount Centris Bracket to Display

7. Slide display with Centris bracket onto array rail (20,

30) (see Figure 12).

NOTE: Repeat previous steps for each additional display.

8. Reinstall end locks into mounting rail using the 5/32"

hex key (120) (see Figure 13).

Display with Centris Bracket

(20, 30)

Figure 12: Mount Display with Centris Bracket to

Array Rail

End Lock

Centris Head

End Lock Retaining Screw

Display

ADJUSTMENTS

Display Adjustment

The KTG Series mount allows horizontal, pitch, and

rotational adjustment of each display.

The KTG Series mount also allows a full 360 deg. of

display rotation with a maximum pitch range of 15° up

and 15° down.

Display Horizontal Position Adjustment

To adjust display horizontal position:

1. Loosen Centris bracket rear adjustment knob (see

Figure 14).

2. Slide Centris bracket with display left or right until

properly positioned on array rail.

3. Tighten Centris bracket rear adjustment knob.

Figure 13: Reinstall End Lock(s)

Figure 14: Display Horizontal Adjustment

Model: KTG-Series

(20, 30)

Centris Head

Horizontal

Adjustment

Knob