Ergo In Demand KTG-230 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Ergo In Demand KTG-230에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ergo In Demand KTG-230 8 페이지. Horizontal and vertical table stands and accessories
페이지 인쇄Installation Instructions
Phillips Pan Head Screw
(170 or 180)
Spacer
(190 or 200)
Figure 11: Mount Centris Bracket to Display
7. Slide display with Centris bracket onto array rail (20,
30) (see Figure 12).
NOTE: Repeat previous steps for each additional display.
8. Reinstall end locks into mounting rail using the 5/32"
hex key (120) (see Figure 13).
Display with Centris Bracket
(20, 30)
Figure 12: Mount Display with Centris Bracket to
Array Rail
End Lock
Centris Head
End Lock Retaining Screw
Display
ADJUSTMENTS
Display Adjustment
The KTG Series mount allows horizontal, pitch, and
rotational adjustment of each display.
The KTG Series mount also allows a full 360 deg. of
display rotation with a maximum pitch range of 15° up
and 15° down.
Display Horizontal Position Adjustment
To adjust display horizontal position:
1. Loosen Centris bracket rear adjustment knob (see
Figure 14).
2. Slide Centris bracket with display left or right until
properly positioned on array rail.
3. Tighten Centris bracket rear adjustment knob.
Figure 13: Reinstall End Lock(s)
Figure 14: Display Horizontal Adjustment
Model: KTG-Series
(20, 30)
Centris Head
Horizontal
Adjustment
Knob
7