Xerox Phaser 750DX Panduan Servis - Halaman 30

Jelajahi secara online atau unduh pdf Panduan Servis untuk Aksesori Printer Xerox Phaser 750DX. Xerox Phaser 750DX 40 halaman. Digital color printer / copier
Juga untuk Xerox Phaser 750DX: Spesifikasi (2 halaman), Brosur & Spesifikasi (4 halaman), Panduan Referensi (8 halaman), Manual (9 halaman)

Halaman Cetak
Xerox Phaser 750DX Panduan Servis
Status
Code
10-360
The control logic sensed an open circuit from the Heat Roll Overheat Thermistor.
Initial action:
Check the Heat Roll Overheat Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-361
The control logic sensed that the Heat Roll did not reach operating temperature.
Initial action:
Ensure that the Heat Roll surface is clean and not damaged (REP 5.31).
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-362
The control logic sensed that the Heat Rod did not turn off after the Heat Roll reached operating temperature.
Initial action:
Ensure that the Heat Roll surface is clean (no debris, paper, etc.) (REP 5.31)
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
Fault Code Procedures
Description/Direction
5/98
2-30
5750 DocuCare Service Manual