Xerox WorkCentre M118 Petunjuk Produksi Ulang - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Produksi Ulang untuk Perangkat lunak Xerox WorkCentre M118. Xerox WorkCentre M118 14 halaman. Drum cartridge remanufacturing
Juga untuk Xerox WorkCentre M118: Panduan Pengguna (2 halaman), Manual Modul (2 halaman), Kartu Instalasi Cepat (2 halaman), Manual Perangkat Lunak (47 halaman), Panduan Pengaturan Cepat (5 halaman), Panduan Pengaturan Cepat (5 halaman), Manual (28 halaman), Manual Pemasangan Dudukan (4 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (1 halaman), Panduan Instalasi (1 halaman), Panduan Memulai (25 halaman), Panduan Evaluator (12 halaman), Panduan Servis (12 halaman)

Halaman Cetak
Xerox WorkCentre M118 Petunjuk Produksi Ulang
XEROX WORKCENTRE M118 • 128 DRUM CARTRIDGE REMANUFACTURING INSTRUCTIONS
2. Remove the four screws from the inner end cap. Remove the end cap.
3. Follow the wires from the inner end cap to the sensor.
Pry up on the two locking tabs and remove the sensor.
Place a small piece of tape over the sensor hole.
www.uninetimaging.com
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]