Xerox WorkCentre M118 Remanufacturing Instructions - Page 3

Browse online or download pdf Remanufacturing Instructions for Software Xerox WorkCentre M118. Xerox WorkCentre M118 14 pages. Drum cartridge remanufacturing
Also for Xerox WorkCentre M118: User Manual (2 pages), Module Manual (2 pages), Quick Installation Card (2 pages), Software Manual (47 pages), Quick Setup Manual (5 pages), Quick Setup Manual (5 pages), Manual (28 pages), Stand Installation Manual (4 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (1 pages), Installation Manual (1 pages), Getting Started Manual (25 pages), Evaluator Manual (12 pages), Service Manual (12 pages)

Print Page
Xerox WorkCentre M118 Remanufacturing Instructions
XEROX WORKCENTRE M118 • 128 DRUM CARTRIDGE REMANUFACTURING INSTRUCTIONS
2. Remove the four screws from the inner end cap. Remove the end cap.
3. Follow the wires from the inner end cap to the sensor.
Pry up on the two locking tabs and remove the sensor.
Place a small piece of tape over the sensor hole.
www.uninetimaging.com
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]